CRUISE CONTROL
Cruise Control Wiring Diagram for Chrysler PT Cruiser 2010
List of elements for Cruise Control Wiring Diagram for Chrysler PT Cruiser 2010:
- (a/t)
- (m/t)
- (near breakout for c103, at left side of engine)
- (near breakout for camshaft position sensor)
- (near breakout for camshaft position sensor) s109
- (near breakout for oxygen sensor 1/1 upstream)
- (on throttle body) throttle position sensor
- A931
- C11
- Can c bus(+)
- Can c bus(-)
- Clutch interlock switch (left side of dash)
- Computer data lines system
- D64
- D65
- Dump
- F855
- Fuse 10a
- Fused b(+)
- G105 (left front inner fender)
- Hot at all times
- Input speed sens sig
- Input speed sensor (on left side of transaxle)
- Interlock sw sig
- Interlock switch sig
- K22
- K75
- K900
- K914
- Output speed sens sig
- Output speed sensor (on left side of transaxle)
- Powertrain control module (on firewall, behind power distribution center)
- Red
- S/c sw 1 sig
- S/c sw rtn
- S106 (2.4l)
- S107 (2.4l turbo)
- S109
- S128 (right front of engine compt)
- Sens gnd
- Sensor gnd 1
- Sensor sig
- Speed control servo (right rear of engine compt)
- Speed control switch
- Speed sig
- Speed signal
- Speed sw sig
- Steering control module (left side of dash)
- Stop lamp switch (left side of dash)
- T14
- T141
- T41
- T52
- Totally integrated power module
- Tp sig
- Transmission range sensor (2.4l) (in transaxle, on top of valve body)
- Trs t41 sns
- V32
- V35
- V36
- V71
- Vacuum
- Vacuum sol
- Vehicle speed sensor (m/t) (on transaxle)
- Vent
- Vent sol