ACTIVE BODYWORKS
Active Bodyworks Wiring Diagram for Cadillac CTS 2010
List of elements for Active Bodyworks Wiring Diagram for Cadillac CTS 2010:
- (6.2l: right rear of engine compt) (except 6.2l: left front of) engine compt) engine control module (ecm)
- (top right of engine) g132
- 3.0l
- 3.6l
- 6.2l
- Automatic transmission
- Batt+ volt
- Body control module (bcm) (center of dash)
- Computer data lines system
- Control solenoid valve assembly
- Data bus+
- Data bus-
- Emis 2 fuse 15a
- Front upper beam pedestrian impact detection sensor
- G102 (right front of engine compt)
- Gnd
- Ground
- Hi spd gmlan serial data bus+
- Hi spd gmlan serial data bus-
- Hi spd gmlan serial data bus- x3
- Hood hi ref
- Hood lo ref
- Hot at all times
- Hot w/ pwr/trn relay energized
- J201
- Left active hood hinge actuator
- Lo ref
- Module sig
- Ped pro fuse 10a
- Pedestrian impact detection module
- Pnk
- Rear upper beam pedestrian impact detection sensor
- Right active hood hinge actuator
- Sensor lo ref
- Sensor sig
- Serial data
- Serial data +
- Serial data -
- Shorting bar
- Tan
- Transmission control module (tcm)
- Underhood fuse block (right front of engine compt)
- Vehicle speed sensor (6.2l m/t) (left rear of transmission)
- Vehicle speed sensor (except 6.2l m/t) (right rear of transmission)
- Vss hi sig
- Vss high sig
- Vss lo sig
- X175