CRUISE CONTROL
4.4L VIN D
4.4L VIN D, Cruise Control Wiring Diagram for Cadillac XLR V 2009
https://portal-diagnostov.com/license.html
https://portal-diagnostov.com/license.html
Automotive Electricians Portal FZCO
Automotive Electricians Portal FZCO List of elements for 4.4L VIN D, Cruise Control Wiring Diagram for Cadillac XLR V 2009:
- (behind lower left side of dash) brake pedal position sensor
- (between driver & passenger seat, behind rear compt stowage trim panel) object alarm module
- (right side of engine compt, under battery) g104
- 5 volt ref
- 5 volt ref 1
- 5 volt ref 2
- A iss signal
- A15
- Acceleration pedal position (app) sensor (top of accelerator pedal assembly)
- App sen 1 sig
- App sen 2 sig
- Automatic transmission
- Automatic transmission input shaft speed (iss) sensor
- Automatic transmission output shaft speed (oss) sensor
- B batt + vol
- Batt5 fuse 5 30a
- Battery positive voltage
- Body control module (bcm) (behind right side of dash)
- Brake pedal position sensor signal
- C oss signal
- Computer data lines system
- Cruise control switch
- Cruise ctrl set/coast & resume/ accel sw signal
- D12
- Data bus +
- Data bus -
- Display
- Engine control module (ecm) (lower right rear of engine compt)
- Ground
- Heads up display (hud) (top left side of dash)
- High speed gmlan serial data bus +
- High speed gmlan serial data bus -
- Hot at all times
- Instrument panel cluster (ipc)
- J211 (in instrument panel harness, approximately 25 cm from park brake pedal assembly breakout)
- J232
- J276
- Logic
- Low ref
- Low reference
- Message request
- Nca
- Off
- Radio
- Red
- Resume/ accel +
- Serial data bus +
- Serial data bus -
- Set/coast
- Stop lamp sw sig
- Stop lamp switch signal
- Switch signal
- Tac motor ctrl-1
- Tac motor ctrl-2
- Tan
- Throttle actuator control (tac) motor
- Throttle body assembly (top of engine, at intake manifold)
- Throttle position (tp) sensor
- Tp sen 1 sig
- Tp sen 2 sig
- Transmission control module
- Turn signal/ multi-function switch
- Underhood fuse block (right rear of engine compt)
- Vehicle speed sig
- Vehicle speed signal
- Vehicle speed signal hud class 2 serial data
4.6L VIN A
4.6L VIN A, Cruise Control Wiring Diagram for Cadillac XLR V 2009
List of elements for 4.6L VIN A, Cruise Control Wiring Diagram for Cadillac XLR V 2009:
- (behind lower left side of dash) brake pedal position sensor
- (between driver & passenger seat, behind rear compt stowage trim panel) object alarm module
- (in instrument panel harness, approxi- mately 25 cm from park brake pedal assembly breakout) j211
- 5 volt ref
- 5-volt ref 2
- Acc gap adjust switch signal
- Acc/ tcm fuse 3 10a
- Acca/driv dr sw fuse 21 10a
- Automatic transmission
- Automatic transmission input shaft speed (iss) sensor
- Automatic transmission output shaft speed (oss) sensor
- Batt
- Batt positive volt
- Bcm high speed gmlan serial data bus +
- Bcm high speed gmlan serial data bus -
- Body control module (bcm) (behind right side of dash)
- Brake pedal position sensor signal
- C10
- Can bus +
- Can bus -
- Computer data lines system
- Cruise control forward vehicle distance sensor
- Cruise control switch
- Cruise ctrl set/coast & resume/ accel sw signal
- Display
- Distance sensing control module (center front of engine compt)
- Driver information center (dic)
- E11
- Engine control module (ecm) (lower right rear of engine compt)
- G102
- G302
- Gnd
- Ground
- Heads up display (hud) (top left side of dash)
- Hot at all times
- Hot w/ run/crank relay 7 energized
- Hud class 2 serial data
- Ign 1
- Ign 1 volt
- Inflatable restraint steering wheel module (center of steering wheel)
- Instrument panel cluster (ipc)
- Ipc class 2 serial data
- J240
- J276
- Left steering wheel control switch
- Logic
- Low ref
- Message request
- Nca
- Off
- Pnk
- Power distribution system
- Radio
- Red
- Resume/ accel +
- Run/ crank relay 7
- Run/ crank rly ctrl
- Serial data bus +
- Serial data bus -
- Set/coast
- Splice pack jx102 (in forward lamp harness, in engine compt, on upper right frame rail, grounded to g102)
- Splice pack jx302 (in instrument panel harness, on right "b" pillar behind trim panel, grounded to g302)
- Stop lamp sw sig
- Stop lamp switch signal
- Tac motor ctrl-1
- Tac motor ctrl-2
- Tan
- Throttle actuator control (tac) motor
- Throttle body assembly (top of engine, at intake manifold)
- Throttle position (tp) sensor
- Tp sens 1 sig
- Tp sens 2 sig
- Transmission control module (tcm)
- Turn signal/ multi-function switch
- Tutd sw/ strg col sw fuse 28 2a
- Underhood fuse block (right rear of engine compt)
- Vehicle speed sig
- Vehicle speed signal
- X1 a15
- X5 k