CRUISE CONTROL
Cruise Control Wiring Diagram for Jeep Grand Cherokee Laredo 2007
List of elements for Cruise Control Wiring Diagram for Jeep Grand Cherokee Laredo 2007:
- (5.7l: right rear of engine) (3.7l & 4.7l: right side of engine) s141
- (near breakout to data link connector) g200
- (on steering wheel) s201
- 3.7l
- 3.7l/5.7l
- 4.7l
- 5.7l
- A108
- Accelerator pedal position sensor (3.7l/5.7l) (5.7l: base of accelerator pedal)
- Apps 1 gnd
- Apps 1 siganal
- Apps 2 gnd
- Apps 2 siganal
- B16
- Brake sw 2 sig
- Engine controls system
- Etc motor (+)
- Etc motor (-)
- F855
- F856
- Fuse 10a
- Fused b (+)
- G103 (right side of engine compt)
- Ground
- Hot at all times
- Hot in run or start
- Junction block (left side of dash)
- K122
- K124
- K126
- K167
- K22
- K23
- K29
- K400
- K900
- K922
- Left speed control switch
- Powertrain control module (right rear of engine compartment)
- Right speed control switch
- S/c sw rtn
- S/c sw sense 1
- S/c sw sense 2
- S/c sw sig 1
- S/c sw sig 2
- S/c vacuum solenoid ctrl
- S/c vent solenoid ctrl
- S106
- S111
- S139 (4.7l: right rear of engine) (3.7l: rear of engine) (5.7l: right rear of engine compt)
- S140 (3.7l: right rear of engine compt) (4.7l & 5.7l: rear of engine)
- S200 (on steering wheel)
- S212
- S218 (on steering wheel)
- S228
- Sensor ground
- Speed control servo (4.7l) (right rear of engine compartment)
- Steering control module (at steering wheel)
- Stop lamp switch (lower left side of dash)
- Throttle body (3.7l/5.7l) (top of engine)
- Throttle position sensor (4.7l) (top of engine)
- Tp 1 sig
- Tp 2 sig
- Tp sensor rtn
- V32
- V35
- V36
- V371
- V372
- V397
- V71
- V72
- V937
- Vacuum
- Vent
- Z907