CRUISE CONTROL
Cruise Control Wiring Diagram for Jeep Wrangler Sahara 2003
List of elements for Cruise Control Wiring Diagram for Jeep Wrangler Sahara 2003:
- (2.4l)
- (4.0l)
- (behind center rear of instrument panel) s215
- (between engine starter solenoid & c182)
- (bottom left end of dash) datalink connector
- (canada)
- (near breakout for ignition coil pack)
- (near breakout to underhood light, on center of firewall)
- (on left side of firewall) s106
- +5v
- Accel resume/
- Brake lamp switch (0n bracket, above brake pedal)
- Brake sw
- Brake switch sense
- Brake transmission shift interlock solenoid (left side of steering column)
- Breakout to c202,c203 &c204) s209
- Cancel
- Clock- spring
- Coast
- Cruise control ind
- D25
- Daytime running lamp module (in rear of engine compt, on firewall)
- Dump
- Fuse 10a
- Fuse block (under right center of dash)
- Fused ignition
- G100 (on left center of firewall)
- G300 (left kick panel)
- Ground
- Hot in run or start
- Instrument cluster
- K29
- Left speed control switch
- Nca
- On/off
- Pci bus
- Powertrain control module (in right rear of engine compt, on firewall)
- Right speed control switch
- S123
- S127 (near breakout to idle air control motor)
- S133
- S135
- S147
- S163 (between g101 and right front wheel speed sensor)
- Sensor gnd
- Set
- Signal
- Speed control servo (left side of engine compt)
- Speed sw sig
- Tan/red
- V32
- V35
- V36
- V37
- Vacuum
- Vacuum sol
- Vehicle speed sensor (on extension housing of transfer case)
- Vent
- Vent sol
- Vss input