SUPPLEMENTAL RESTRAINTS
Supplemental Restraints Wiring Diagram for Cadillac Seville STS 2003
List of elements for Supplemental Restraints Wiring Diagram for Cadillac Seville STS 2003:
- (left seat harness, 52.5 cm from forward/back position sensor) s313
- (on right side of dash, near blower motor) dash integration module (dim)
- A10
- A11
- A12
- A13
- A14
- A15
- A16
- A17
- A18
- Air bag indicator
- Case ground
- Computer data lines system
- Data link connector (dlc) (partial) (under left side of dash, near steering column)
- G201
- G306 (under right front seat, near inflatable restraint sensing & diagnostic module (sdm) connector)
- Ground
- High control
- Hot in run & start
- Ignition
- Inflatable restraint i/p module
- Inflatable restraint sensing & diagnostic module (sdm) (under right front seat)
- Inflatable restraint steering wheel module
- Inflatable restraint steering wheel module coil
- Instrument panel cluster (ipc)
- Instrument panel integration module (ipm) (behind center of dash above radio)
- Left front inflatable restraint side impact module
- Left front seat belt pretensioner
- Left front seat belt switch (in driver seat belt buckle)
- Left inflatable restraint side impact sensor (sis) (on base of left "b" pillar, behind trim panel)
- Low control
- Nca
- Rear fuse block (under left rear seat)
- Remote player cd changer
- Right front inflatable restraint side impact module
- Right front seat belt pretensioner
- Right inflatable restraint side impact sensor (sis) (on base of right "b" pillar, behind trim panel)
- Seat belt switch
- Serial data class 2
- Shorting bar
- Signal
- Sir fuse 15a
- Solid state
- Sp201 (right front corner of the passenger compartment, under front of sill trim plate)
- Tan
- Voltage