WARNING SYSTEMS
Warning Systems Wiring Diagram for Cadillac XLR 2007
List of elements for Warning Systems Wiring Diagram for Cadillac XLR 2007:
- Ajar
- Audible alarm
- Auto
- Bcm class 2 serial data
- Bcm high spd gmlan serial data bus +
- Bcm high spd gmlan serial data bus -
- Body control module (bcm) (behind right side of dash)
- C1 a5
- Class 2 (rcdlr)
- Class 2 (sdm)
- Closed
- Computer data lines system
- Driver door latch
- Driver seat belt buckle
- Driver seat belt switch
- Ecm high spd gmlan serial data bus +
- Ecm high spd gmlan serial data bus -
- Engine control module (ecm) (lower right rear of engine compt)
- G201
- G301
- Head
- Inflatable restraint sensing & diagnostic module (sdm) (under center console)
- Instrument panel cluster (ipc)
- Internal antenna
- Ipc
- Ipc class 2 serial data
- Left front tire pressure monitor sensor
- Left rear tire pressure monitor sensor
- Left seat belt sw
- Lf dr open sw sig
- Lf turn sig sw
- Logic
- Low ref
- Low tire pressure ind
- Message center
- Message request
- Nca
- Off
- Open
- Park
- Pk lmp sw on sig
- Pnk
- Remote control door lock receiver (rcdlr) (behind right side of dash)
- Rf turn sig sw
- Rfa class 2 serial data
- Right front tire pressure monitor sensor
- Right rear tire pressure monitor sensor
- S275
- S375
- S391 (in driver's seat harness, approximately 4.0 cm from inflatable restraint seat position switch breakout)
- Sdm class 2 serial data
- Seat belt ind
- Solid state
- Sp201 (in instrument panel harness, at base of left a pillar behind trim panel, grounded to g201)
- Sp301 (in instrument panel harness, on left "b" pillar behind trim panel, grounded to g301)
- Tan
- Turn signal/ multifunction switch