CRUISE CONTROL
Cruise Control Wiring Diagram for Ford Contour SE 1997
List of elements for Cruise Control Wiring Diagram for Ford Contour SE 1997:
- 29s
- A/t
- Battery
- Brake on/off switch (top of brake pedal support)
- Brake pedal switch (top of brake pedal support)
- C136
- C201
- C221
- Clock- spring assembly
- Clutch pedal position switch (top of clutch pedal)
- Coast
- Deactivation in
- Engine compartment fuse box
- Exterior lights system
- Fuse 15a
- Fuse 7.5a
- G111 (battery support)
- Ground
- Horn
- Horn relay
- Hot at all times
- Hot in acc or run
- Hot in run
- Ignition
- Interior fuse panel
- M/t
- Nca
- Off
- Park/neutral position (pnp) switch (top of trans)
- Power distribution system
- Remote entry module (under right side of i/p)
- Resume
- S204 (fuse box harn, near safety wall harn, in breakout to 8 pin inline connector, above interior fuse panel)
- S205
- Set/accel
- Speed control cutout relay (left side of i/p)
- Speed control module (left rear corner of engine compt)
- Speed control/horn switch
- Switch in
- Switch return
- Traction control disable switch
- Vehicle speed sensor (lower rear of transaxle)
- Vss in
- W/ drl
- W/ remote entry only
- W/ traction control only
- W/o drl
- W/o traction control
- W/traction control