SUPPLEMENTAL RESTRAINTS – Ford Ranger 2004 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraints Wiring Diagram for Ford Ranger 2004

List of elements for Supplemental Restraints Wiring Diagram for Ford Ranger 2004:

• (at left front of vehicle floor) g205
• (under front of center console) g204
• Air bag ind ctrl
• Air bag indicator
• Air bag sliding contact (at bottom of steering column)
• Air bag tone driver
• Buckled
• C218b
• C220a
• C220b
• C2280c
• Computer data lines system
• Data link connector (dlc) (at bottom of steering column)
• Dedicated ground
• Driver air bag feed
• Driver air bag return
• Driver air bag unit (in steering wheel)
• Driver safety belt feed
• Driver safety belt retractor pretensioner (at left rear of vehicle floor)
• Driver safety belt rtn
• Fuse 10a
• Fuse 5a
• Hot in run or start
• Ignition
• Instrument cluster
• Iso bus
• Microprocessor
• Nca
• Near breakout for center of dash) s201
• Off
• Pad switch ind ctrl
• Pad switch input
• Pass air bag feed
• Pass air bag return
• Pass safety belt feed
• Pass safety belt rtn
• Passenger air bag deactivation (pad) switch
• Passenger air bag module (behind right side of dash)
• Passenger safety belt retractor pretensioner (at right rear of vehicle floor)
• Pin shorting bars engaged when module connector is disconnected from harness: (shorting bars are connected between following pins: 3-4, 6-7 & 20-21)
• Pretensioner
• Restraints control module (under front of center console)
• S206 (in main harness, near breakout for audio unit)
• S208 (in main harness, near breakout for audio unit)
• Safety belt ind
• Shorting bar
• Smart junction box (cjb) (behind right side of dash)
• Steering column air bag sliding contact)
• Tone sig
• Unbuckled
• Warning chime