WARNING SYSTEMS
Warning Systems Wiring Diagram for Oldsmobile Aurora 2003
List of elements for Warning Systems Wiring Diagram for Oldsmobile Aurora 2003:
- A11
- A12
- A15
- A16
- Ajar switch
- Auto
- Class 2 serial data
- Computer data lines system
- Dash integration module (dim) (behind dash, under right dash sound insulator)
- Door ajar switch
- Door open sw signal
- Driver door lock actuator
- Driver door module (ddm)
- G200
- G201
- Ground
- Head
- Headlamp switch
- Headlamps on signal
- Ignition switch
- Inflatable restraint sensing & diagnostic module (sdm) (under center console, mounted to floor pan)
- Instrument panel cluster (ipc)
- Instrument panel integration module (ipm) (at center of dash, behind heater & a/c controls)
- Key in ignition signal
- Key-in-ignition switch (closed w/key in ignition)
- Left front seat belt switch (closed w/seat belt unbuckled)
- Left turn lamps
- Logic
- Low reference
- Nca
- Off
- Open switch
- Park
- Park brake switch
- Park lamps on signal
- Powertrain control module (pcm) (at left side of engine compartment, under air cleaner)
- Radio
- Right turn lamps
- S205
- S226
- S250 (in i/p ground harness, 16.5 cm from c210 harness breakout)
- S251 (in i/p ground harness, 10 cm from c210 harness breakout)
- Seat belt sw signal
- Splice pack sp200 (in lower left front corner of passenger compartment, on left front windshield pillar)
- Splice pack sp201 (in lower right corner of passenger compartment, on right front windshield pillar)
- Tan
- Turn signal/hazard flasher module (behind left side of dash, above data link connector)