STARTING/CHARGING
Charging Wiring Diagram for Saturn Ion 2 2006
https://portal-diagnostov.com/license.html
https://portal-diagnostov.com/license.html
Automotive Electricians Portal FZCO
Automotive Electricians Portal FZCO List of elements for Charging Wiring Diagram for Saturn Ion 2 2006:
- (in engine harness, 5 cm from engine harness breakout)
- (or rust)
- 2.0l
- 2.2l
- 2.4l
- Battery
- Body control module (bcm) (at lower center of dash)
- Charge indicator
- Cluster/aos fuse 7.5a
- Cycle sig
- Engine control module (ecm) (2.2l & 2.4l) powertrain control module (pcm) (2.0l) (2.2l & 2.4l: at left side of engine compartment) (2.0l: at rear of engine, near coolant overflow container)
- G201 (behind lower left side of dash, left of steering column)
- G502 (at right rear side of trunk)
- Gen field duty
- Gen turn on sig
- Generator
- Gnd
- Hot at all times
- Instrument panel cluster (ipc)
- Logic
- Power distribution system
- Red
- S150
- S250
- Serial data (class 2)
- Starter
- Underhood fuse block (at left rear side of engine compt)
Starting Wiring Diagram for Saturn Ion 2 2006
List of elements for Starting Wiring Diagram for Saturn Ion 2 2006:
- 2.2l
- 2.4l
- 5v ref
- A/t
- B10
- Battery
- Bcm class 2 serial data
- Body control module (bcm) (at lower center of dash)
- Charging circuit
- Clutch start switch (below left side of dash, on clutch pedal bracket)
- Clutch/ brake/aos fuse 7.5a
- Crank fuse 46 30a
- Ecm class 2 serial data
- Ecm cont relay 31
- Engine control module (ecm) (at left side of engine compartment)
- G502 (at right rear side of trunk)
- Hot in acc or run
- Ign fuse 11 10a
- Ignition switch
- Logic
- M/t
- Off acc
- Off/run/crank voltage
- Park/neutral position (pnp) switch (on top of transaxle)
- Pnk
- Pnp/clutch start switch signal
- Power distribution system
- Powertrain relay 29
- Red
- Run
- Rust
- Start
- Starter
- Starter relay coil control
- Underhood fuse block (at left rear side of engine compartment)