CRUISE CONTROL
Cruise Control Wiring Diagram for Nissan Murano SL 2010
List of elements for Cruise Control Wiring Diagram for Nissan Murano SL 2010:
- (in steering wheel) combination switch (spiral cable)
- Accelerator pedal position sensor (above accelerator pedal)
- Acsd steering switch
- Aps1
- Aps2
- Ascd brake switch (on brake pedal bracket)
- Ascd sw
- Avcc1-aps1
- Avcc1-tps-b1
- Avcc2-aps2
- Bncsw
- Brake
- Can-h
- Can-l
- Cancel
- Combination meter
- Computer data lines system
- Cruise ind & set ind
- E10
- E103
- E16
- E38
- Electric throttle control actuator (integral to throttle body)
- Engine control module (ecm) (left side of engine compt)
- Engine controls system
- F12
- Fuse 10a
- Fuse 51 15a
- Fuse block j/b (left end of dash)
- Gnd
- Gnda-aps1
- Gnda-aps2
- Gnda-ascdsw
- Gnda-tps-b1
- Hot at all times
- Hot in on or start
- Ipdm e/r (intelligent power distribution module engine room) (left side of engine compt)
- M303
- M33
- Main (on/off)
- Motor1-b1
- Motor2-b1
- Motrly-b1
- Nca
- Pnk
- Red
- Resume/ accelerate
- Sensor 1
- Sensor 2
- Set/ coast
- Stoplight switch (on brake pedal bracket)
- Throttle control motor
- Throttle control motor relay
- Throttle position sensor
- Tps1-b1
- Tps2-b1
- Vbr
- Vehcan-h
- Vehcan-l
- Vmot-b1