CRUISE CONTROL
Cruise Control Wiring Diagram for Nissan Sentra SR 2009
List of elements for Cruise Control Wiring Diagram for Nissan Sentra SR 2009:
- (behind left end of dash)
- (in steering column) combination switch (spiral cable)
- (on brake pedal bracket) stop light switch
- Accel/res switch
- Accelerator pedal position sensor (on accelerator pedal bracket)
- Acsd steering switch
- Aps1
- Aps2
- Ascd brake switch (on brake pedal bracket)
- Ascd clutch switch (on clutch pedal bracket)
- Ascd sw
- Avcc-aps1
- Avcc-aps2
- Avcc-tps
- Bnc sw
- Brake
- Can-h
- Can-l
- Can-l gnda ascdsw
- Cancel switch
- Closed
- Coast/ set
- Combination meter
- Computer data lines system
- Cruise ind
- Cvt
- E16
- E39
- E43
- E46
- Ecm (on left side of firewall)
- Electric throttle control actuator (on throttle body)
- F23
- F24
- F25
- Fuse 10a
- Fuse 52 15a
- Fuse block j/b
- Gnd
- Gnda-aps1
- Gnda-aps2
- Gnda-tps
- Hot at all all times
- Hot at all times
- Hot in on or start
- Ign
- Ipdm e/r (intelligent power distribution module engine room) (left front of engine compt)
- M/t
- M30
- M57
- M78
- Motor 1
- Motor 2
- Motrly
- On/off (main) switch
- Open
- Pnk
- Pri sens
- Primary speed sensor (left side of transaxle)
- Red
- Sec sens
- Secondary speed sensor (top of transaxle)
- Sen gnd
- Sens
- Sens(gnd)
- Sensor 1
- Sensor 2
- Set ind
- Switch
- Throttle control motor relay
- Tps1
- Tps2
- Transmission control module (tcm) (left front of engine compartment)
- Unified meter control unit
- Vehicle speed sensor (w/o abs or cvt) (top right side of clutch housing)
- Vmot