CRUISE CONTROL
Cruise Control Wiring Diagram for Nissan Xterra SE 2003
List of elements for Cruise Control Wiring Diagram for Nissan Xterra SE 2003:
- (left kick panel) m14
- (not used)
- 4th cut sw
- A/t
- Ascd brake switch (on bracket, above brake pedal)
- Ascd clutch switch (on bracket, above clutch pedal)
- Ascd control unit (behind dash, left of steering column)
- Ascd motor actuator (at left front corner of engine compt)
- Ascd relay
- Ascd steering switch
- Brake nc sw
- Brake sw
- Cancel switch
- Clutch
- Clutch gnd
- Clutch pwr
- Coast/ set switch
- Combination meter
- Command sw
- Cruise
- Cruise lamp
- Cruise sw
- Fuse 11 10a
- Fuse 12 10a
- Fuse 22 15a
- Fuse 5 10a
- Fuse block (at left side of dash, behind cover)
- Ground
- Hot at all times
- Hot in on or start
- Ign
- M/t
- M14 (left kick panel)
- M38
- M39
- Motor
- Motor 1
- Motor 2
- Motor 3
- On/off switch
- Park/neutral position (pnp) switch (a/t) (on right side of transmission)
- Resume/ accel switch
- Set
- Set lamp
- Spiral cable
- Stoplight switch (on bracket, above brake pedal)
- Transmission control module (tcm) (a/t) (behind dash, left of steering column)
- Unified meter control unit (w/odo/ trip meter)
- Vehicle speed
- Vehicle speed sensor (on bottom left rear of transmission)