SUPPLEMENTAL RESTRAINTS
Supplemental Restraint Wiring Diagram for Nissan Maxima SE 2002
List of elements for Supplemental Restraint Wiring Diagram for Nissan Maxima SE 2002:
- (behind right seat- back) b106
- (center front of engine compartment) e149
- (left "b" pillar) b7
- Air bag
- Air bag diagnosis sensor unit (under rear of floor center console)
- Air bag w/l
- As1 +
- As1 -
- As2 +
- As2 -
- B135
- B42
- Combination meter
- Combination switch (spiral cable)
- Crash zone sensor
- Data link connector (dlc) (partial) (lower left side of dash)
- Dr -
- Dr1 +
- Dr2 +
- Driver air bag module
- Eczs +
- Eczs -
- Eczs gnd
- Fastened
- Fuse 10a
- Fuse block (j/b) (behind left side of dash)
- Gnd
- Hot in on or start
- Ignition
- K-line
- Left satellite sensor (if equipped) (at base of left "b" pillar)
- Left seat belt buckle switch (in left seat belt buckle)
- Left seat belt pre-tensioner
- Left side air bag module (if equipped)
- M146
- M25 (behind left side of dash)
- M32
- M33
- Nca
- Nca (left "b" pillar) b44
- Nca (right "b" pillar) b128
- Passenger air bag module
- Plh +
- Plh -
- Pnk
- Prh +
- Prh -
- Red
- Right satellite sensor (if equipped) (at base of right "b" pillar)
- Right seat belt buckle switch (in right seat belt buckle)
- Right seat belt pre-tensioner
- Right side air bag module (if equipped)
- Sat lh +
- Sat lh -
- Sat lh gnd
- Sat rh +
- Sat rh -
- Sat rh gnd
- Slh +
- Slh -
- Srh +
- Srh -
- Switch input
- Un- fastened