SUPPLEMENTAL RESTRAINTS
Supplemental Restraints Wiring Diagram for Nissan Xterra SE 2003
List of elements for Supplemental Restraints Wiring Diagram for Nissan Xterra SE 2003:
- (at right kick panel) m68
- (under left side of dash, near fuse box cover)
- 11p
- A/bag w/l
- Air bag diagnosis sensor unit (under console box)
- Air bag warning lamp
- Clh +
- Clh -
- Combination meter
- Corner of engine compartment) e54
- Crash zone sensor (at center front of engine compartment)
- Crh +
- Crh -
- Czs +
- Czs -
- Data link connector (partial)
- Dr1 (-) dr2 (-)
- Dr1 +
- Dr2 +
- Driver air bag module
- Fastened
- Front passenger air bag module
- Fuse 10a
- Fuse block (j/b) (at left side of dash, behind cover)
- Gnd
- Gnd (shield)
- Hot in on or start
- Ignition
- K-line
- Left front seat belt pre-tensioner
- Left seat belt buckle switch
- Left side air bag (satellite) sensor (at left "b" pillar)
- Left side curtain air bag module (if equipped)
- M113
- M114
- M115
- M14 (at left kick panel)
- M202
- M206
- M38
- M39
- M68 (at right kick panel)
- Nca
- Pas1 +
- Pas1 -
- Pas2 +
- Pas2 -
- Plh +
- Plh -
- Prh +
- Prh -
- Red
- Right front seat belt pre-tensioner
- Right seat belt buckle switch
- Right side air bag (satellite) sensor (at right "b" pillar)
- Right side curtain air bag module (if equipped)
- Seat belt sw
- Spiral cable
- Un- fastened