TRANSMISSION
A/T Wiring Diagram for Mitsubishi Diamante LS 2001
List of elements for A/T Wiring Diagram for Mitsubishi Diamante LS 2001:
- (2001)
- (forward of center console) auto- cruise ecu
- (forward of center console) traction control ecu
- (left front of engine compt) (2001) vehicle speed sensor
- (right rear of engine compt) g4
- (under front of center console)
- (under left side of dash)
- A/t control relay (under right side of dash, near center console)
- A/t control solenoid valve assembly (in transaxle)
- A/t oil temp
- Acc
- Accelerator pedal position sensor (on throttle body)
- Assist ecu (under right side of dash, near kick panel)
- B-108
- B-109
- B-110
- B-111
- B-113
- B-52
- B-53
- B-76
- B-77
- B-80
- Back-up lights system
- Computer data lines system
- Cruise control system
- Data link connector
- Engine compartment relay box (left front fender)
- Engine controls system
- Engine coolant temperature sensor (left side of engine compt)
- Exterior lights system
- Flash memory connector (under left side of dash)
- Fuse 10a
- Fuse 15a
- Fuse 20a
- G14
- G14 (under front of center console)
- Hot at all times
- Hot in run or start
- Idle sw
- Ignition switch
- Input shaft speed sensor (on transaxle)
- Junction block (behind left side of dash)
- Lock
- Low/ reverse
- Mfi relay (front of shifter, under center console)
- Output shaft speed sensor (on transaxle)
- Over drive
- Park/neutral position switch (left front of engine compt)
- Powertrain control module (under center of dash, forward of center console)
- Red
- Run
- Second
- Start
- Starting system
- Stop- light switch (above brake pedal)
- Throttle position sensor (on throttle body)
- Torque converter control
- Under drive
- W/ tcl
- W/o tcl