TRANSMISSION
2.4L
2.4L, A/T Wiring Diagram for Mitsubishi Outlander GT 2013
https://portal-diagnostov.com/license.html
https://portal-diagnostov.com/license.html
Automotive Electricians Portal FZCO
Automotive Electricians Portal FZCO List of elements for 2.4L, A/T Wiring Diagram for Mitsubishi Outlander GT 2013:
- (in engine room relay box) cvt control relay
- (not used)
- A-12
- A-13
- Auto mode
- C-129
- C-301
- C-304
- C-312
- C-313
- C-317
- C-33
- C-34
- C-37
- C-38
- Can drive circuit
- Circuit interface
- Circuit transceiver can
- Combination meter
- Computer data lines system
- Cpu
- Cvt assembly
- Cvt failure) cvt temperature (cvt position lcd
- Engine compartment relay box (left side of engine compt)
- Etacs-ecu (left side of dash)
- Exterior lights system
- Fuse 15a
- Fuse 20a
- Fuse 7.5a
- G1 (right front of engine compt)
- G19 (under left end of dash)
- G2 (right rear of engine compt)
- G6 (behind left side of dash)
- Hot at all times
- Hot w/ ig1 relay energized
- Ill
- Interface circuit
- Interior lights system
- Line pressure solenoid valve
- Lock-up selection solenoid valve
- Lock-up solenoid valve
- Nca
- Paddle shift switch (if equipped)
- Pnk
- Primary pulley speed sensor (on transaxle)
- Red
- Rom-assembly
- Secondary pressure solenoid valve
- Secondary pulley speed sensor (top of transaxle)
- Secondary transmission fluid pressure sensor
- Select switch
- Selector lever assembly
- Shift switch
- Sport mode
- Stepper motor
- Stoplight switch (above brake pedal, on bracket)
- Transaxle control module (behind left side of dash)
- Transmission fluid temperature sensor
- Transmission range switch (top of transaxle)
- Used) (not
2.4L, AWD Wiring Diagram for Mitsubishi Outlander GT 2013
List of elements for 2.4L, AWD Wiring Diagram for Mitsubishi Outlander GT 2013:
- (2wd 4wd auto 4wd lock)
- (behind left side of dash) g6
- 2wd
- 4wd
- Awd-ecu (behind left side of dash)
- C-138
- C-301
- C-313
- C-315
- C-317
- C-318
- C-32
- Can drive circuit
- Circuit can transceiver
- Circuit interface
- Combination meter
- Computer data lines system
- Cpu
- D-113
- Drive mode selector
- Electronic control coupling solenoid (at rear of transfer case)
- Etacs-ecu (left side of dash)
- Fuse 10a
- Fuse 15a
- Fuse 7.5a
- G10 (left rear corner of vehicle)
- G6 (behind left side of dash)
- Hot at all times
- Hot w/ ig1 relay energized
- Ill
- Interface circuit
- Interior lights system
- Lcd
- Lock
- Nca
- Pnk
3.0L
3.0L, A/T Wiring Diagram for Mitsubishi Outlander GT 2013
List of elements for 3.0L, A/T Wiring Diagram for Mitsubishi Outlander GT 2013:
- (behind left side of dash)
- (in engine room relay box) a/t control relay
- (right rear of engine compt) g2
- 2-6 brake linear solenoid valve
- 2-6 brake pressure switch
- 3-5 reverse clutch linear solenoid valve
- A-12
- A-13
- A/t control solenoid valve assembly (on rear of transaxle)
- Auto mode
- C-129
- C-301
- C-304
- C-312
- C-313
- C-317
- C-33
- C-34
- C-37
- C-38
- Can drive circuit
- Can transceiver circuit
- Combination meter
- Computer data lines system
- Cpu
- Engine compartment relay box (left side of engine compt)
- Etacs-ecu (left side of dash)
- Exterior lights system
- Fuse 15a
- Fuse 20a
- Fuse 7.5a
- G1 (right front of engine compt)
- G19 (under left end of dash)
- G6 (behind left side of dash)
- High clutch linear solenoid valve
- High clutch pressure switch
- Hot at all times
- Hot w/ ig1 relay energized
- Ill
- Input shaft speed sensor (top center of transaxle)
- Interface circuit
- Interior lights system
- Lcd (a/t position a/t temperature a/t failure)
- Line pressure linear solenoid valve
- Lock-up & low-reverse brake linear solenoid valve
- Low clutch linear solenoid valve
- Low clutch shift solenoid valve
- Low-reverse brake pressure switch
- Low-reverse brake shift solenoid valve
- Nca
- Output shaft speed sensor (top right of transaxle)
- Paddle shift switch (if equipped)
- Pnk
- Red
- Select switch
- Selector lever assembly
- Shift switch
- Sport mode
- Stoplight switch (above brake pedal, on bracket)
- Transaxle control module (behind left side of dash)
- Transmission fluid temperature sensor
- Transmission range switch (top of transaxle)
3.0L, AWD Wiring Diagram for Mitsubishi Outlander GT 2013
List of elements for 3.0L, AWD Wiring Diagram for Mitsubishi Outlander GT 2013:
- (2wd 4wd auto 4wd lock)
- (behind left side of dash) g6
- 2wd
- 4wd
- Awd-ecu (behind left side of dash)
- C-138
- C-301
- C-313
- C-315
- C-317
- C-318
- C-32
- Can drive circuit
- Circuit can transceiver
- Circuit interface
- Combination meter
- Computer data lines system
- Cpu
- D-113
- Drive mode selector
- Electronic control coupling solenoid (at rear of transfer case)
- Etacs-ecu (left side of dash)
- Fuse 10a
- Fuse 15a
- Fuse 7.5a
- G10 (left rear corner of vehicle)
- G6 (behind left side of dash)
- Hot at all times
- Hot w/ ig1 relay energized
- Ill
- Interface circuit
- Interior lights system
- Lcd
- Lock
- Nca
- Pnk