TRANSMISSION
Transmission Wiring Diagram for Mitsubishi Outlander SE 2006
List of elements for Transmission Wiring Diagram for Mitsubishi Outlander SE 2006:
- (behind lower right side of dash)
- A/t control relay (on engine compartment relay box)
- A/t control solenoid valve assembly (on rear of transaxle)
- A/t fluid temp sensor
- A/t temp ind
- Auto
- C-04
- C-05
- C-103
- C-109
- C-110
- C-111
- C-112
- C-202
- C-205
- C22 data link connector (below left side of dash)
- C23
- Combination meter
- Control circuit
- Engine compartment relay box (on left side of engine compt)
- Engine controls system
- Exterior lights system
- Fuse 15a
- Fuse 20a
- Fuse 7.5a
- G6 (behind left side of dash)
- Hot at all times
- Hot in run or start
- Input shaft speed sensor (on top center of transaxle)
- J/c 1 (behind right side of dash, taped to harness)
- J/c 2 (behind right side of dash, taped to harness) red
- J/c 3 (behind left end of dash)
- Junction block (behind left end of dash)
- Low/ rev
- Mfi relay (on engine compartment relay box)
- Output shaft speed sensor (on top right of transaxle)
- Over drive
- Powertrain control module (behind glove box)
- Red
- Second
- Shift ind
- Shift switch assembly (at gear selector assembly)
- Sport
- Stop light switch (above brake pedal, on bracket)
- Tac motor
- Throt- tle actu- ator control motor relay (on engine compt relay box)
- Throttle position sensor (on throttle body)
- Torque converter clutch control
- Transmission range switch (at left front of engine compt)
- Under drive