TRANSMISSION
A/T Wiring Diagram for Nissan Altima SE 2003
List of elements for A/T Wiring Diagram for Nissan Altima SE 2003:
- (left rear of transaxle) park/neutral position switch
- (left side of engine compart) dropping resistor
- 1 pos
- 2 pos
- 2.5l
- 2.5l 3.5l
- 3 pos
- 3.5l
- A/t check
- A/t device (3rd position switch)
- A/t fluid temp sensor
- Automatic transaxle
- Avcc
- Can-h
- Can-l
- Combination meter
- D pos
- Data link connector (below left side of dash)
- Duty sol
- Ect
- Electronic throttle control actuator (integral with throttle body, on intake manifold)
- Engine control module (ecm) (behind glove box)
- Engine coolant temperature sensor (2.5l: left rear of engine) (3.5l: upper rear of engine)
- Exterior lights
- F14 (front of engine)
- Fuse 10a
- Fuse block (behind left side of dash)
- Gnd
- Gnd sens
- Gnd-a
- Hot at all times
- Hot in on or start
- Ign
- Intelligent power distribution module engine room (ipdm e/r) (behind right headlight)
- J/c 1 (behind upper left side of dash)
- Line press sol valve
- Lu duty
- M57 (behind right side of dash)
- Mem b/u
- N pos
- Nca
- Oil temp
- Over- run clutch sol
- Ovr/c
- P pos
- P/n out
- P/n pos
- P/t sens
- Pnk
- R pos
- Red
- Revolution sensor (right rear of transaxle)
- Shift sol valve a
- Shift sol valve b
- Sp sens
- Ssa
- Ssb
- Starting/ charging system
- Tacho
- Tcc sol valve
- Tps 1
- Tps 2
- Transmission control module (tcm) (behind right side of dash)
- Turbine revolution sensor (right rear of transaxle)
- Tv01
- Tvoo
- V sens
- Vehicle speed sensor (right front of transaxle)
- Vig
- Vss in
- Vss out