TRANSMISSION
Transmission Wiring Diagram for Nissan Maxima SE 2003
List of elements for Transmission Wiring Diagram for Nissan Maxima SE 2003:
- (left rear side of transaxle) park/neutral position switch
- (near air cleaner box) dropping resistor
- 1 pos
- 10k
- 11k
- 2 pos
- 3 pos
- A/t check ind
- A/t chk
- A/t device (3rd position switch)
- A/t fluid temp sensor
- Abs actuator & electric unit (left rear corner of engine compt)
- Abs/tcs control unit (left rear corner of engine compt)
- Accelerator pedal position sensor (above accelerator pedal)
- Aps 1
- Automatic transaxle
- Avcc
- Brk sw
- Can-h
- Can-l
- Combination meter
- D pos
- Data link connector (below)
- Duty sol
- Ect
- Engine control module (ecm) (behind lower center of dash)
- Engine coolant temperature sensor (left rear of engine)
- Exterior lights system
- F42 (front of engine)
- Fuse 10a
- Fuse 15a
- Fuse block (behind left side of dash)
- Gnd
- Gnd sens
- Gnd-a
- Hot at all times
- Hot in on or start
- J/c 20 (behind center of dash)
- J/c 3 (behind left side of dash)
- Left side of dash)
- Line press sol valve
- Lu duty
- M25 (below left side of dash)
- Mem b/u
- Nca
- Oil temp
- Over- run clutch sol
- Ovr/c
- P/n pos
- P/t sens
- Pnk
- Powertrain revolution sensor (right rear of transaxle)
- Pwr
- R pos
- Red
- Revolution sensor (top right rear of transaxle)
- Shift sol valve a
- Shift sol valve b
- Ssa
- Ssb
- Starting/ charging system
- Stoplamp switch (on brake pedal bracket)
- Tach
- Tacho
- Tcc sol valve
- Th/sen
- Transmission control module (tcm) (below lower center of dash)
- Tvo0
- V sens
- Vign
- Vss in
- Vss out
- Vss-1
- Vss-2
- W/ traction control
- W/o traction control