COMPUTER DATA LINES – Subaru Legacy GT spec.B 2008 – SYSTEM WIRING DIAGRAMS

COMPUTER DATA LINES

Computer Data Lines Wiring Diagram for Subaru Legacy GT spec.B 2008

List of elements for Computer Data Lines Wiring Diagram for Subaru Legacy GT spec.B 2008:

• (4 speed)
• (a/t) transmission control module
• (at right rear corner of engine compartment) vdc control module
• (at steering column) steering angle sensor
• (on right rear of engine) ge
• (right side of engine compartment) abs control module
• 2.5l
• 2.5l turbo
• 3.0l
• 4 speed
• 5 speed
• 6 mt 5 mt
• A/c lock sensor shield
• Ab6
• Accelerator pedal position sensor shield
• Air bag control module (under center console)
• Auto a/c control module
• B122
• B134
• B135
• B136
• B170
• B186
• B280
• B282
• B365
• B52
• B54
• B55
• B75
• B76
• Body integrated unit (center of dash)
• Can joint connector
• Can joint connector (center of dash)
• Combination meter
• Cruise control switch
• Data link connector (under left side of dash)
• Electronic throttle control shield
• Engine control module
• Fuse & relay block (f/b) (left end of dash)
• Fuse 13 7.5a
• Fuse 4 15a
• Gb-4
• Hot at all times
• Hot w/ ig2 relay energized
• I10
• I106
• I107
• I119
• I84
• Joint connector (right side of dash)
• Main fuse box (m/b) (left side of engine compartment)
• Nca
• Neutral position switch (m/t) (on transmission)
• Pcv diagnosis connector (2.5l)
• Pnk
• Red
• Test mode connector
• Tpm control module (under driver's seat)
• Tv monitor
• W/ navigation
• W/ vdc
• W/o navigation
• W/o vdc
• Yaw rate sensor (below center console)