STARTING/CHARGING – Chevrolet Tracker 1998 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Chevrolet Tracker 1998

List of elements for Charging Wiring Diagram for Chevrolet Tracker 1998:

• Acc
• Batt fuse 80a
• Battery
• Charge indicator
• Daytime running lamps control module (behind left side of dash)
• Fuse block 1 (right rear of engine compt, front of battery)
• Fuse block 2 (under left side of dash)
• G105 (right inner fender, near battery)
• G120 (right engine, near starter motor)
• Generator
• Ig fuse 60a
• Ig-coil meter fuse 15a
• Ignition switch
• Instrument panel cluster assembly
• Junction connector 2 (under left side of dash)
• Lock
• Run
• S130
• S205
• S241 (main harn, 2cm from pcm connectors breakout)
• S272
• Start
• Starter solenoid

Starting Wiring Diagram for Chevrolet Tracker 1998

List of elements for Starting Wiring Diagram for Chevrolet Tracker 1998:

• 3-speed
• 4-speed
• A/t
• Acc
• Batt fuse 80a
• Battery
• Clutch pedal position switch (on clutch pedal support)
• Cruise control system
• Engine controls system
• Fuse block 1 (right side of engine compt., front of battery)
• G105 (right inner fender, near battery)
• G120 (right engine, near starter motor)
• Ig fuse 60a
• Ignition switch
• Lock
• M/t
• P or n
• Park/ neutral position switch (right side of trans)
• Red
• S100 (main harn, approx. 21 cm from front wiper motor breakout)
• S136
• S248
• Start
• Starter
• Starter solenoid
• Transmission range switch (right side of trans)