WARNING SYSTEMS
Warning Systems Wiring Diagram for Chevrolet Malibu LS 2011
List of elements for Warning Systems Wiring Diagram for Chevrolet Malibu LS 2011:
- (under center console)
- Abs ind
- Acc
- Air bag ind
- Ajar
- Auto
- Batt sense fuse 54 5a
- Body control module (bcm) (under center console)
- Brake fluid level switch (on brake master cylinder reservoir)
- Brake fluid lvl sw
- Brake ind
- Charge ind
- Chime
- Computer data lines system
- Driver door latch (driver's door)
- Driver information center (dic) display
- Driver seat belt buckle
- Driver seat belt switch
- Engine coolant temp ind
- G109 (left front corner of engine compt)
- G201 (under center console)
- G301 (right "c" pillar)
- Head
- Hot at all times
- Ign sensor fuse 2a
- Ignition switch
- Inflatable restraint sensing & diagnostic module (sdm)
- Instrument panel cluster (ipc)
- Key in ignition switch
- Left
- Left rear door latch (left rear door)
- Left seat belt sw
- Left turn ind
- Lf dr ajar sw sig
- Logic
- Low engine oil pressure ind
- Low ref
- Low spd gmlan serial data
- Low spd gmlan serial data bus
- Low speed gmlan serial data
- Low tire pressure ind
- Lr dr ajar sw sig
- Lr trn sig sw
- Off
- Off/run/ crank voltage
- Park
- Park brake sw sig
- Park brake switch (left kick panel)
- Park lp sw sig
- Passenger door latch (front passenger's door)
- Pnk
- Radio
- Rf dr ajar sw sig
- Right
- Right rear door latch (right rear door)
- Right turn ind
- Rr dr ajar sw sig
- Rr trn sig sw
- Run
- Seat belt ind
- Serial data bus
- Service vehicle soon ind
- Start
- Turn signal/ multi-function switch
- Underhood fuse block (left side of engine compt)
- X300
- X500
- X600
- X700
- X800