Wiring Diagram VW PASSAT CC 2009 - Control unit for electromechanical parking brake - parking brake motor left and right - lateral acceleration sender - yaw rate sender - longitudinal acceleration sender
https://portal-diagnostov.com/license.html
https://portal-diagnostov.com/license.html
Automotive Electricians Portal FZCO
Automotive Electricians Portal FZCO
G200 | Lateral acceleration sender |
G202 | Yaw rate sender |
G251 | Longitudinal acceleration sender |
G476 | Clutch position sender |
J104 | ABS control unit |
J540 | Control unit for electromechanical parking brake |
SC2 | Fuse 2 on fuse holder C |
SC22 | Fuse 22 on fuse holder C |
SC24 | Fuse 24 on fuse holder C |
T2an | 2-pin connector, black |
T2ao | 2-pin connector, black |
T5j | 5-pin connector |
T30 | 30-pin connector |
T38 | 38-pin connector |
V282 | Left parking brake motor |
V283 | Right parking brake motor |
688 | Earth point 2, on centre tunnel |
B287 | Connection 11 (15a), in main wiring harness |
B384 | Connection 2 (powertrain CAN bus, high), in main wiring harness |
B391 | Connection 2 (powertrain CAN bus, low), in main wiring harness |
* | Only models with manual gearbox |
** | Only models with automatic gearbox |
*** | Only models with auto-hold function |
Wiring Diagram VW PASSAT CC 2009 - Control unit for electromechanical parking brake - button for electromechanical parking brake
E538 | Button for electromechanical parking brake, left of dash panel |
E540 | AUTO HOLD button, near gear selector |
J285 | Control unit in dash panel insert |
J540 | Control unit for electromechanical parking brake |
K213 | Electromechanical parking brake warning lamp |
K237 | Auto-hold warning lamp |
L76 | Button illumination bulb |
SC17 | Fuse 17 on fuse holder C |
T6h | 6-pin connector |
T10i | 10-pin connector |
T30 | 30-pin connector |
T32c | 32-pin connector |
249 | Earth connection 2, in interior wiring harness |
396 | Earth connection 31, in main wiring harness |
639 | Earth point, left A-pillar |
687 | Earth point 1, on centre tunnel |
B332 | Connection 18 (30a), in main wiring harness |
B340 | Connection 1 (58d), in main wiring harness |
B482 | Connection 18, in main wiring harness |
*** | Only models with auto-hold function |
Wiring Diagram VW PASSAT CC 2009 - Dash panel insert - multifunction display - data bus diagnosis interface
VW PASSAT CC 2009 Overview of control units
Overview of control units | 1 - | Auxiliary heater control unit -J364- |
2 - | Power steering control unit -J500- |
3 - | ABS control unit -J104- |
4 - | Automatic gearbox control unit -J217- |
4 - | Voltage stabiliser -J532- |
5 - | Engine control unit -J623- |
6 - | Adaptive cruise control unit -J428- |
Auxiliary heater control unit -J364- | behind the right front wheel housing liner | - | Auxiliary heater control unit -J364- | - | 2-pin connector -T2- -T2cn- | - | 8-pin connector -T8- -T8ai- | | | |
VW PASSAT CC 2009 Power steering control unit J500Power steering control unit -J500- | At the steering on the subframe | A - | 5-pin connector -T5- -T5z- | B - | 2-pin connector -T2- -T2fn | | | |
On bulkhead, on right in engine compartment -arrow- | - | 38-pin connector -T38- -T38- | | | |
Automatic gearbox control unit -J217- | In front left wheel housing -arrow- | - | 52-pin connector -T52- -T52- | | | |
Voltage stabiliser -J532- | In front left wheel housing -arrow- | - | 12-pin connector -T12- -T12ad- | | | |
Engine control unit -J623- | under centre of plenum chamber cover -arrow- | A - | 94-pin connector -T94- -T94- | B - | 60-pin connector -T60- -T60- | | | |
Adaptive cruise control unit -J428- | behind radiator in centre -arrow- | - | 10-pin connector -T10- -T10y- | | | |
Mechatronic unit for dual clutch gearbox -J743- |
1 - | Mechatronic unit for dual clutch gearbox -J743- |
A - | 20-pin connector -T20m- |
Note: The illustration does not correspond with the selected vehicle, but the fitting location is the same. | | | |