Components - MAIN BEAM HEADLAMPS - Fiat DOBLO 1.6 16v da 12/03
Component code | Description | Reference to the assembly |
B001 | JUNCTION UNIT | |
B2 | JUNCTION UNIT UNDER DASHBOARD | |
C10 | LEFT FRONT EARTH | |
C15 | DASHBOARD EARTH, DRIVER''S SIDE | |
E50 | INSTRUMENT PANEL | |
F010 | LEFT HEADLAMP | |
F011 | RIGHT HEADLAMP | |
H001 | IGNITION SWITCH | |
H5 | STEERING COLUMN SWITCH UNIT | |
M001 | BODY COMPUTER |
Component code | Description | Reference to the assembly |
B001 | JUNCTION UNIT | |
B2 | JUNCTION UNIT UNDER DASHBOARD | |
C10 | LEFT FRONT EARTH | |
C15 | DASHBOARD EARTH, DRIVER''S SIDE | |
E50 | INSTRUMENT PANEL | |
F010 | LEFT HEADLAMP | |
F011 | RIGHT HEADLAMP | |
H001 | IGNITION SWITCH | |
H5 | STEERING COLUMN SWITCH UNIT | |
M001 | BODY COMPUTER |
The vehicle is fitted with two special main beam headlamps.These are activated:- with the dipped beams on, by pushing the stalk toward the facia (stable mode);- in flashing mode, by pulling the lever toward the steering wheel (unstable mode).The circuit is protected by two fuses in the engine compartment junction unit. one for the right headlamp and one for the left.A warning light on the instrument panel indicates main beam activation.
The main beams are activated by an earth signal from stalk unit H05 when the wheel is operated which reaches the body computer M01 at pin 33 connector F.To switch the main beam headlamps on the body computer activates the relay R2 housed in the engine compartment junction unit B01 from pin 9 connector C. Another activation signal reaches relay R2 at the same time coming from the ignition switch H01 and entering pin 30 connector B of the engine compartment junction unit B01.The latter receives a power supply directly from pin 1 connector A and sends it to the left and right headlamps at the outlets for pins 22 and 25 of connector B respectively.Each line is protected by a fuse in the engine compartment junction unit B01: F15 for the left headlamp, F14 for the right.The body computer M01 also controls the switching on of the warning light in the instrument panel E50.The body computer may be supplied via pin 11 connector E (ignition controlled power supply) and pin A connector C (direct power supply) of junction unit B02.There is a protective fuse F1 for the direct power supply located in the engine compartment junction unit B01.These lines also supply the instrument panel E50 via two lines protected by fuses F37 and F53.Pins 8 and 9 of connector D of the body computer are earthed.