ENGINE PERFORMANCE – Mitsubishi Endeavor LS 2010 – SYSTEM WIRING DIAGRAMS

ENGINE PERFORMANCE

3.8L

3.8L, Engine Performance Wiring Diagram (1 of 5) for Mitsubishi Endeavor LS 2010

List of elements for 3.8L, Engine Performance Wiring Diagram (1 of 5) for Mitsubishi Endeavor LS 2010:

• (behind instrument cluster) j/c 1
• (left front of engine compt) g12
• (main)
• (sub)
• (under left side of dash) data link connector
• (under left side of dash) stoplight switch
• A-13
• Accelerator pedal position sensor (above accelerator pedal)
• Air conditioning system
• B-18
• B-19
• B-20
• C-31
• C-32
• C-46
• Computer data lines system
• Cruise control system
• Engine compartment relay box (left side of engine compt)
• Evaporative emission ventilation solenoid (near fuel tank, on evaporative emission canister)
• Fuel tank differential pressure sensor (top of fuel tank)
• Fuse 15a
• Fuse 20a
• G11 (front of engine compt)
• G12 (left front of engine compt)
• G13 (near engine compt relay box)
• Hall ic
• Hot at all times
• Knock sensor (top center of engine)
• Navigation system
• Nca
• Pnk
• Power steering pressure switch (lower right side of engine compt)
• Powertrain control module (left front of engine compt)
• Red
• Starting/charging system

3.8L, Engine Performance Wiring Diagram (2 of 5) for Mitsubishi Endeavor LS 2010

List of elements for 3.8L, Engine Performance Wiring Diagram (2 of 5) for Mitsubishi Endeavor LS 2010:

• (on engine compt relay box) mfi relay
• (on engine compt relay box) throttle actuator control motor relay
• A-13
• A/t control solenoid valve assembly (left side of engine compartment)
• C-204
• C-211
• C-214
• C-31
• Engine coolant temperature sensor (near throttle body)
• Fuel pump relay 1
• Fuel pump relay 2
• Fuse 10a
• Fuse 7.5a
• G8 (behind lower center of dash)
• Hot in on or start
• J/c
• J/c (behind instrument cluster)
• Junction block (left end of dash)
• Low & reverse solenoid valve
• Manifold absolute pressure sensor (on intake manifold)
• Nca
• Overdrive solenoid valve
• Red
• Second solenoid valve
• Torque converter clutch control solenoid valve
• Transmission fluid temperature sensor
• Underdrive solenoid valve

3.8L, Engine Performance Wiring Diagram (3 of 5) for Mitsubishi Endeavor LS 2010

List of elements for 3.8L, Engine Performance Wiring Diagram (3 of 5) for Mitsubishi Endeavor LS 2010:

• (behind instrument cluster) j/c 3
• A/t temp
• Combination meter
• Computer data lines system
• Converter)
• Cpu
• G7 (behind instrument cluster)
• Ind
• Interior lights system
• Left bank heated oxygen sensor (front) (on inlet of left catalytic
• Left bank heated oxygen sensor (rear) (on outlet of left bank catalytic converter)
• Mass airflow sensor (left side of engine compt)
• Mil ind
• Nca
• Pnk
• Red
• Rheostat circuit
• Right bank heated oxygen sensor (front) (on inlet of right catalytic
• Right bank heated oxygen sensor (rear) (on outlet of right catalytic

3.8L, Engine Performance Wiring Diagram (4 of 5) for Mitsubishi Endeavor LS 2010

List of elements for 3.8L, Engine Performance Wiring Diagram (4 of 5) for Mitsubishi Endeavor LS 2010:

• (in top of fuel tank) fuel pump module
• (on engine compt relay box) a/t control relay
• (on top of transaxle) transmission range switch
• A-13
• Auto mode
• B-32
• C-32
• Camshaft position sensor (rear of engine)
• Crankshaft position sensor (on front of engine, next to crankshaft sprocket)
• Exhaust gas recirculation valve (left side of engine compt)
• Exterior lights system
• Fuel level sensor (main)
• Fuel tank temperature sensor
• G15 (under left front seat)
• G16 (on top of left rear wheelwell)
• Injector 1 (top of right cylinder bank)
• Injector 2 (top of left cylinder bank)
• Injector 3 (top of right cylinder bank)
• Injector 4 (top of left cylinder bank)
• Injector 5 (top of right cylinder bank)
• Injector 6 (top of left cylinder bank)
• Instrument cluster system
• Nca
• Off
• Pnk
• Red
• Select switch
• Shift switch (down)
• Shift switch (up)
• Shift switch assembly
• Sport mode
• Starting/ charging system

3.8L, Engine Performance Wiring Diagram (5 of 5) for Mitsubishi Endeavor LS 2010

List of elements for 3.8L, Engine Performance Wiring Diagram (5 of 5) for Mitsubishi Endeavor LS 2010:

• (main)
• (on top of transaxle) input shaft speed sensor
• (on top of transaxle) output shaft speed sensor
• (sub)
• (top rear of engine) throttle body assembly
• B-21
• B-22
• B-32
• Evaporative emission purge solenoid (center rear of engine compt)
• G11 (front of engine compt)
• Hall ic
• Ignition coil 1 (top of right cylinder bank)
• Ignition coil 2 (top of left cylinder bank)
• Ignition coil 3 (top of right cylinder bank)
• Ignition coil 4 (top of left cylinder bank)
• Ignition coil 5 (top of right cylinder bank)
• Ignition coil 6 (top of left cylinder bank)
• Nca
• Pnk
• Powertrain control module (left front of engine compt)
• Red
• Spark plug
• Starting/charging system
• Throttle actuator control motor