ENGINE PERFORMANCE – Nissan Cube 2011 – SYSTEM WIRING DIAGRAMS

ENGINE PERFORMANCE

1.8L

1.8L, Engine Performance Wiring Diagram (1 of 3) for Nissan Cube 2011

List of elements for 1.8L, Engine Performance Wiring Diagram (1 of 3) for Nissan Cube 2011:

• (top of engine)
• (top of engine) condenser
• Af heater gnd
• Aps1
• Aps2
• Ascd sw
• Avcc-aps1
• Avcc-aps2
• Bnc sw
• Brake
• Can-h
• Can-l
• Cdcv
• Computer data lines system
• Cruise control system
• E105
• E16
• E38
• Ecm (left rear of engine room)
• Evap
• F6 (front of engine)
• Fpr
• Fuel injector 1
• Fuel injector 2
• Fuel injector 3
• Fuel injector 4
• Fuse 10a
• Fuse block (j/b) (left side of dash)
• Gnda-aps1
• Gnda-aps2
• Gnda-ascd sw
• Gnda-to
• Ground
• Hot at all times
• Ign 1
• Ign 2
• Ign 3
• Ign 4
• Ign sw
• Ignition coil 1 (w/ power transistor) (top of engine)
• Ignition coil 2 (w/ power transistor) (top of engine)
• Ignition coil 3 (w/ power transistor) (top of engine)
• Ignition coil 4 (w/ power transistor) (top of engine)
• Inj 1
• Inj 2
• Inj 3
• Inj 4
• K-line
• M77
• Motor1
• Motor2
• Motrly
• Nca
• Neut-h
• O2hr
• Plug spark
• Pnk
• Red
• Scv 1
• Scv 2
• Ssoff
• Stop lamp switch (left side of dash)
• Vbr
• Vmot
• Vscv

1.8L, Engine Performance Wiring Diagram (2 of 3) for Nissan Cube 2011

List of elements for 1.8L, Engine Performance Wiring Diagram (2 of 3) for Nissan Cube 2011:

• (front of engine) intake valve timing control solenoid valve
• (right rear of vehicle) evap canister vent control valve
• Accelerator pedal position (app) sensor (top of accelerator pedal assembly)
• Close
• Cpu
• E105
• E13
• E14
• E15
• Ecm relay
• Electric throttle control actuator (on throttle body)
• Engine oil temperature sensor (california)
• Fuel pump relay
• Fuse 10a
• Fuse 15a
• Fuse 20a
• Hot at all times
• Hot in on or start
• Hot w/ ignition relay energized
• Ipdm e/r (intelligent power distribution module engine room) (left rear of engine compt)
• M18
• M77
• M77 e105
• M79
• Open
• Pnk
• Red
• Sensor 1
• Sensor 2
• Throttle control motor
• Throttle control motor relay
• Throttle position sensor
• Tumble control valve actuator (california)
• Tumble control valve motor
• Tumble control valve position sensor
• W/ intelligent key
• W/o intelligent key

1.8L, Engine Performance Wiring Diagram (3 of 3) for Nissan Cube 2011

List of elements for 1.8L, Engine Performance Wiring Diagram (3 of 3) for Nissan Cube 2011:

• (left side of engine block) knock sensor
• (on engine intake air duct) mass airflow sensor (w/ intake air temperature sensor)
• (rear of cylinder head)
• (rear of engine room) evap canister purge volume control solenoid valve
• (top of fuel tank) fuel level sensor unit & fuel pump
• (top rear of engine) engine coolant temperature sensor
• Af+
• Af-
• Air fuel ratio (a/f) sensor 1 (rear of engine room)
• Avcc-cursen
• Avcc-ftpres
• Avcc-pdres
• Avcc-phase
• Avcc-pos
• Avcc-scvpos
• Avcc-tps
• B57
• Batt
• Battery current sensor (cvt) (near battery)
• Camshaft position sensor (phase)
• Can-h
• Can-l
• Combination meter
• Computer data lines system
• Crankshaft position sensor (pos) (lower front of engine)
• Cursen
• Cvt
• Cvtc
• E105
• Ecm (left rear of engine room)
• Evap control system pressure sensor (near evap canister)
• F1 e8
• Ftpres
• Fuel pump
• Fuel tank temperature sensor
• Fuse 10a
• Fuse block (j/b) (left side of dash)
• Gnd-phase
• Gnd-pos
• Gnda-cursen
• Gnda-ftpres
• Gnda-knk
• Gnda-o2sr
• Gnda-pdpres
• Gnda-scvpos
• Gnda-ta
• Gnda-tps
• Gnda-tw
• Heated oxygen sensor (in exhaust between three way catalysts)
• Hot in on or start
• Iat sensor
• Knk
• M/t
• M18
• M77
• M77 e105
• M79
• M79 b4
• Malfunction indicator lamp
• O2sr
• Park/neutral position switch (top of transmission)
• Pdpres
• Phase
• Pnk
• Pos
• Qa+
• Qa-
• Red
• Refrigerant pressure sensor (under alternator)
• Scvpos
• Sens gnd fuel level
• Sens sig fuel level
• Shield
• Starting/ charging system
• Tps1
• Tps2
• Transmission range switch (top of transmission)