ENGINE PERFORMANCE – Nissan Cube SL 2014 – SYSTEM WIRING DIAGRAMS

ENGINE PERFORMANCE

1.8L

1.8L, Engine Performance Wiring Diagram (1 of 3) for Nissan Cube SL 2014

List of elements for 1.8L, Engine Performance Wiring Diagram (1 of 3) for Nissan Cube SL 2014:

• (top of engine)
• (top of engine) condenser
• Aps1
• Aps2
• Ascd brake sw
• Ascd sw
• California
• Can-h
• Can-l
• Computer data lines system
• Cruise control system
• Data link conn
• E105
• E16
• E38
• Ecm (left rear of engine room)
• Ecm ground
• Ecm rly
• Evap
• Exterior lights system
• F6 (front of engine)
• Fpr
• Fuel injector 1
• Fuel injector 2
• Fuel injector 3
• Fuel injector 4
• Fuse 10a
• Fuse block (j/b) (left side of dash)
• Ground
• Hot at all times
• Ign 1
• Ign 2
• Ign 3
• Ign 4
• Ign sw
• Ignition coil 1 (w/ power transistor) (top of engine)
• Ignition coil 2 (w/ power transistor) (top of engine)
• Ignition coil 3 (w/ power transistor) (top of engine)
• Ignition coil 4 (w/ power transistor) (top of engine)
• Inj 1
• Inj 2
• Inj 3
• Inj 4
• M77
• Mot rly
• Motor (close)
• Motor (open)
• Motor (open) a/f sensor 1 heater
• Nca
• O2hr
• Oil temp sens
• Plug spark
• Pnk
• Pnp sig
• Pwr sply
• Pwr sply for ecm
• Red
• Sens gnd
• Sens pwr sply
• Sns gnd
• Stop lamp switch (left side of dash)
• Stop lp sw
• Vscv

1.8L, Engine Performance Wiring Diagram (2 of 3) for Nissan Cube SL 2014

List of elements for 1.8L, Engine Performance Wiring Diagram (2 of 3) for Nissan Cube SL 2014:

• (front of engine) intake valve timing control solenoid valve
• (right rear of vehicle) evap canister vent control valve
• Accelerator pedal position sensor (top of accelerator pedal assembly)
• Close
• Cpu
• E105
• E13
• E14
• E15
• Ecm relay
• Electric throttle control actuator (on throttle body)
• Engine oil temperature sensor (california)
• Except canada
• Fuel pump relay
• Fuse 10a
• Fuse 15a
• Fuse 20a
• Hot at all times
• Hot in on or start
• Hot w/ ignition relay energized
• Ipdm e/r (intelligent power distribution module engine room) (left rear of engine compt)
• M18
• M77
• M77 e105
• M79
• Open
• Pnk
• Red
• Sensor
• Sensor 1
• Sensor 2
• Throttle control motor
• Throttle control motor relay
• Throttle position sensor
• Tumble control valve actuator (california)
• Tumble control valve motor
• Tumble control valve position sensor
• W/ intelligent key
• W/o intelligent key

1.8L, Engine Performance Wiring Diagram (3 of 3) for Nissan Cube SL 2014

List of elements for 1.8L, Engine Performance Wiring Diagram (3 of 3) for Nissan Cube SL 2014:

• (left side of engine block) knock sensor
• (on engine intake air duct) mass air flow sensor (w/ intake air temperature sensor)
• (rear of engine room) evap canister purge volume control solenoid valve
• (top of fuel tank) fuel level sensor unit & fuel pump
• (top rear of engine) engine coolant temperature sensor
• A/f sens 1
• Air flow sens
• Air fuel ratio (a/f) sensor 1 (rear of engine room)
• Air temp sens
• B57
• Batt current sens
• Battery current sensor (cvt) (near battery)
• Camshaft position sensor (phase) (rear of cylinder head)
• Can-h
• Can-l
• Combination meter
• Computer data lines system
• Crankshaft position sensor (pos) (lower front of engine)
• Cvt
• E105
• Ecm (left rear of engine room)
• Evap control system pressure sensor (near evap canister)
• Except canada
• F1 e8
• Fuel level sensor
• Fuel pump
• Fuel tank temperature sensor
• Fuse 10a
• Fuse block (j/b) (left side of dash)
• Heated oxygen sensor 2 (in exhaust between three way catalysts)
• Hot in on or start
• Iat sensor
• Intake valve
• Knk snsr
• M/t
• M18
• M77
• M77 e105
• M79
• M79 b4
• Malfunction indicator lamp
• O2sr
• Park/neutral position switch (top of transmission)
• Phase
• Pnk
• Position sns (gnd)
• Pwr sply for ecm
• Qa-
• Red
• Ref prs sens
• Refrigerant pressure sensor (under alternator)
• Scvpos
• Sens gnd
• Sens gnd fuel level
• Sens pwr sply
• Sens sig fuel level
• Shield
• Starting/ charging system
• Temp sens
• Tps1
• Transmission range switch (top of transmission)