CRUISE CONTROL – Lincoln Mark LT 2008 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Lincoln Mark LT 2008

List of elements for Cruise Control Wiring Diagram for Lincoln Mark LT 2008:

• (back-up light switch to rear light feed harness, near breakout to powertrain control module (pcm)) s141
• (engine control sensor harness, near breakout to c139) s104
• (main wiring harness, near breakout to ignition switch) s296
• (under left side of dash) brake pedal position switch
• Acceleration pedal position (app) sensor (at top of brake pedal assembly)
• App1
• App2
• App3
• Boo
• Bps
• C175b
• C175e
• C175t
• C218b
• C270b
• C270f
• Can bus +
• Can bus -
• Central junction box (cjb) (near right "a" pillar)
• Clockspring (in steering column)
• Clutch position sensor (top of clutch pedal assembly)
• Coast
• Computer data lines system
• Cpp bt
• Cpp tt
• Deactivator switch (on brake pedal bracket)
• Electronic throttle control (etc) motor (on throttle body)
• Electronic throttle position sensor (on throttle body)
• Engine controls system
• Etc ref
• Etcref
• Etcrtn
• Fuse 10a
• Fuse 20a
• G102 (right rear of engine compt)
• G103 (right rear of engine compt)
• Gnd
• Horn switch
• Horns system
• Hot at all times
• Hot in start or run
• Illumination
• Interior lights system
• Nca
• Off
• Oss
• Output shaft speed (oss) sensor (left side of transmission)
• Powertrain control module (pcm) (right rear of engine compt)
• S102
• S109 (engine control sensor harness, near breakout to left front wheel speed sensor)
• S112
• S220
• Sccs
• Sccsrtn
• Set
• Sig rtn
• Sigrtn
• Solid state
• Sound systems
• Speed control switch
• Tacm+
• Tacm-
• Tan
• Tp1
• Tp2