ELECTRONIC SUSPENSION – Pontiac Bonneville SE 1995 – SYSTEM WIRING DIAGRAMS

ELECTRONIC SUSPENSION

Computer Command Ride for Pontiac Bonneville SE 1995

List of elements for Computer Command Ride for Pontiac Bonneville SE 1995:

• (below left front seat)
• 10a
• C 1995 vftc
• C10
• C11
• C12
• C13
• C14
• C15
• C16
• Computer command ride (ccr) controller (below left front seat)
• D10
• D11
• D12
• D13
• D14
• D15
• D16
• Data link connector (right side of steering column)
• Diagnostic test in
• Diagnostic test out
• Driver shift select switch
• Firm input
• Fuse 5b
• G101 (right front of eng compt, above right horn)
• G200 (left kickpad)
• Ground
• Hot in run
• I/p fuse block (left side of i/p)
• Ign input
• Junction connector c215 (behind right side of i/p)
• Lateral accel sw in
• Lateral acceleration switch
• Left front strut
• Left rear strut
• Lf motor drive
• Lf position in
• Lr motor drive
• Lr position in
• Nca
• Normal input
• Perf
• Pnk
• Pos out 2
• Pos out 3
• Powertrain control module (behind right side of i/p, near kickpad)
• Red
• Rf motor drive
• Rf position in
• Right front strut
• Right rear strut
• Rr motor drive
• Rr position in
• Tour
• Vehicle speed input
• Vehicle speed output
• Wot input
• Wot output

Electronic Level Control (with Assembly Inflator) for Pontiac Bonneville SE 1995

List of elements for Electronic Level Control (with Assembly Inflator) for Pontiac Bonneville SE 1995:

• (left front of eng compt, above left horn)
• * pressure passes through: -air dryer (maintains pressure in strut at 48-97 kpa, 7-14 psi) -pressure limiter valve limits maximum pressure in struts to 447-510 kpa, 64-74 psi)
• A-closes with vehicle too high. b-closes 17-27 seconds after change in vehicle height. remains closed approximately 7 minutes maximum. c-closes with vehicle too low.
• C 1995 vftc
• Compressor assembly
• Compressor signal
• Elc compressor assembly (left side of engine compartment beside wheelhouse)
• Elc height sensor (below rear of vehicle, on frame above right rear lower suspension arm)
• Elc relay (position e)
• Exhaust solenoid
• From actu- ator arm
• Fuse 5b 10a
• Fuse 9b 20a
• G100
• G200 (left kickpad)
• Gnd
• Hot at all times
• Hot in run
• I/p fuse block (left side of i/p)
• Inflator solenoid valve (right front luggage compartment near wheelhouse)
• Inflator switch (center rear of luggage compart- ment)
• Inflator timer relay (right front of luggage compartment near wheelhouse)
• Level
• Nca
• Off
• Power
• Relay center (behind right i/p, above sound insulator)
• Reset
• Reset
• Reset after 10 minutes
• Solid state
• To rear struts
• Too high
• Too low
• Vent

Electronic Level Control (without Assembly Inflator) for Pontiac Bonneville SE 1995

List of elements for Electronic Level Control (without Assembly Inflator) for Pontiac Bonneville SE 1995:

• to struts
• (c-car) (h-car)
• (relay center)
• A-closes with vehicle too high. b-closes 17-27 seconds after change in vehicle height. remains closed approximately 7 minutes maximum. c-closes when
• Compressor signal
• Elc compres- sor assembly (left side of eng compt)
• Elc height sensor (left rear underbody)
• Elc relay posi- tion e
• Enable and vehicle is too low.
• Exhaust solenoid
• From actu- ator arm
• Fuse 5b 10a
• Fuse 9b 20a
• G100 (left front of eng compt, above left horn)
• G200 (left kickpad)
• Hot at all times
• Hot in run
• I/p junction block (left side of i/p)
• J/c c340 (left front door e sill) d
• Level
• Motor
• Nca
• Power
• Reset
• Solid state
• Too high
• Too low
• Vent