CRUISE CONTROL – Chevrolet Monte Carlo SS 2003 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Monte Carlo SS 2003

List of elements for Cruise Control Wiring Diagram for Chevrolet Monte Carlo SS 2003:

• (chassis harness, 13 cm from fuel pump flow control module) j364
• (left end of dash) left i/p junction block
• (on 3rd body mount) (w/ 20 series hybrid) g305
• (or 2250)
• (w/ one piece liftgate w/ liftglass, 10 cm from breakout to left rear shock absorber actuator) (except one piece liftgate w/ liftglass, 8 cm from breakout to fuel pump/trailer brake control module) j360
• 5v ref
• Comm data
• Computer data lines system
• Drain wire
• Enable sig
• Engine controls system
• Exterior lights system
• Front fuel & sender assembly
• Fscm fuse 21 20a
• Fuel pressure sensor (except 6.0l (vin g))
• Fuel pump ctrl
• Fuel pump/ trailer brake control module (w/ 10 series) trailer brake control module (w/ 20 series)
• G300 (on 2nd body mount)
• G400 (w/ 10 series except hybrid) (left rear body mount)
• Gain sig
• Gmlan +
• Gmlan -
• Gnd
• Hot at all times
• Hot w/ run/crnk relay energized
• Ign 1
• Interior lights system
• J300
• Low ref
• Misc ign fuse 43 10a
• Pnk
• Power distribution system
• Press sens sig
• Rly enable
• Rly feedback
• Stop lamp switch (top of brake pedal bracket)
• Stud 2 fuse 63 30a
• Tan
• Tcc brk sig
• Trailer brake control relay (under left rear of vehicle)
• Trailer brake control switch
• Trailer connector (center rear of vehicle)
• Trl brk rly
• Trl brk sig
• Underhood fuse block (left side of engine compt)
• W/ 10 series
• W/ 20 series
• X123
• X205