SUPPLEMENTAL RESTRAINTS – Chevrolet Beretta 1995 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Chevrolet Beretta 1995

List of elements for Supplemental Restraint Wiring Diagram for Chevrolet Beretta 1995:

• A10
• A11
• A12
• Airbag in-line fuse 3a
• Arming sens feed
• Arming sens sig
• Arming sensor (right upper i/p, attatched to underside of upper dash panel)
• B10
• B11
• B12
• Diagnostic energy reserve module (derm) (behind right front kick panel)
• Dlc
• Forward discriminating sensor (attached to radiator support)
• Fuse 3 10a
• Fuse 9 20a
• Fuse block (left side of i/p)
• G104 (left rear of engine compt)
• Hot in run, bulb test or start
• Hot in start when in p/n (a/t) or when clutch fully depressed (m/t)
• Ign fuse output
• Ign output
• Ind lp output
• Inflatable restraint ind
• Inflator feed
• Inflator module
• Inflator output
• Instrument cluster
• M data link conn (left lower hush panel)
• Nca
• Passenger compt discriminating sensor (under center console)
• Pnk
• Seat belt sw
• Shorting bar
• Sir coil assembly
• Sir gnd
• Start input
• Tan
• Warning system (seat belt switch)