STARTING/CHARGING – Isuzu Trooper S 1990 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

2.6L

2.6L, Charging Wiring Diagram for Isuzu Trooper S 1990

List of elements for 2.6L, Charging Wiring Diagram for Isuzu Trooper S 1990:

• Battery
• Charge warning light
• Engine relay
• Fuse 10a
• Fuse 15a
• Fuse block (left side fender panel in engine compartment)
• Fusible link box (right front corner of engine compartment)
• G100 (left fender near fuse block)
• G101 (lower right front of engine compartment)
• G113 (lower right side of frame)
• G131 (right side of engine compart- ment on intake manifold)
• Generator
• Hot in on or start
• Indicators
• Instrument panel
• Starting system (starter solenoid)

2.6L, Starting Wiring Diagram for Isuzu Trooper S 1990

List of elements for 2.6L, Starting Wiring Diagram for Isuzu Trooper S 1990:

• A/t
• Acc
• Battery
• Clutch start switch (top of clutch pedal support)
• Electronic control module (below console)
• Engine controls system
• Fuse 20a
• Fuse block (left side engine compart- ment)
• Fuse block (left side engine compartment)
• Fusible link box (right front corner of engine compartment)
• G105 (rear of right fender)
• G105 (rear of right front fender)
• G113 (right side of engine com- partment at battery tray)
• G113 (right side of frame)
• G131 (intake manifold)
• Hot at all times
• Ignition switch
• Lock
• M/t
• Nca
• Off
• Run
• Start
• Starter assembly
• Starter relay
• Transmission position switch

2.8L

2.8L, Charging Wiring Diagram for Isuzu Trooper S 1990

List of elements for 2.8L, Charging Wiring Diagram for Isuzu Trooper S 1990:

• Battery
• C213
• Charge warning indicator
• Fuse 10a
• Fuse 15a
• Fuse block (left side fender panel in engine compartment)
• Fusible link box (right front corner of engine compartment)
• G101 (lower right corner of engine com- partment on frame)
• G113 (right side of engine compartment at battery tray)
• G131 (front center of engine)
• Generator
• Hot in
• In-line resistor (behind left side of dash)
• Instrument panel
• On or start
• Starting system (starter solenoid)

2.8L, Starting Wiring Diagram for Isuzu Trooper S 1990

List of elements for 2.8L, Starting Wiring Diagram for Isuzu Trooper S 1990:

• A/t
• Accy
• B10
• Battery
• Clutch start switch
• Diode box a (behind left side of dash)
• Electronic control module (under center console)
• Fuse 10a
• Fuse block (left side engine compartment)
• Fusible link box (right front corner of engine compartment)
• G100 (left side of engine compartment above fuse block)
• G101 (lower right corner of engine compartment on frame)
• G113 (right side of engine compartment at battery tray)
• G131 (front center of engine)
• G207 (left side of dash above steering column)
• Ignition switch
• Lock
• M/t
• Off
• Start
• Starter assembly
• Starter relay (right side engine compartment on relay bracket)
• Transmission position switch