AUTOMOTIVE ELECTRICIANS PORTAL

WARNING SYSTEMS – Infiniti FX45 2004 – SYSTEM WIRING DIAGRAMS

WARNING SYSTEMS

Chime Wiring Diagram for Infiniti FX45 2004

Chime Wiring Diagram for Infiniti FX45 2004 https://portal-diagnostov.com/license.html
https://portal-diagnostov.com/license.html Automotive Electricians Portal FZCO Automotive Electricians Portal FZCO
Download PDF file

List of elements for Chime Wiring Diagram for Infiniti FX45 2004:

  • (behind instrument cluster) m45
  • (on floor near driver seat) b15
  • 15a
  • 61a
  • 8a m1
  • B14
  • Bat (f/l)
  • Bat (fuse)
  • Batt
  • Belt ind
  • Body control module (bcm) (behind left kick panel)
  • Buzzer
  • Can-h
  • Can-l
  • Comb sw in 1
  • Comb sw in 2
  • Comb sw in 3
  • Comb sw in 4
  • Comb sw in 5
  • Comb sw out 1
  • Comb sw out 2
  • Comb sw out 3
  • Comb sw out 4
  • Comb sw out 5
  • Combination meter
  • Combination switch
  • Computer data lines system
  • Door ind
  • Door sw (dr)
  • Driver side front door switch
  • Driver side front power seat
  • Fuse 10a
  • Fuse 15a
  • Fuse block (j/b) (behind left kick panel)
  • Fuse, fusible link & relay block (right rear of engine compt)
  • Fusible link m 50a
  • Gnd
  • Gnd (power)
  • Gnd (signal)
  • Hot at all times
  • Hot in on or start
  • Ign sw
  • Ignition knob switch
  • Input 1
  • Input 2
  • Input 3
  • Input 4
  • Input 5
  • Inserted
  • Intelligent ket unit (if equipped) (behind left eng of dash)
  • Joint connector 7 (early production) (base of left "b" pillar)
  • Key sw
  • Key switch
  • Key switch & ignition knob switch (w/ intelligent key)
  • M45 (behind instrument cluster)
  • Output 1
  • Output 2
  • Output 3
  • Output 4
  • Output 5
  • Push sw
  • Pushed
  • Red
  • Removed
  • Rx (comb meter)
  • Seat belt buckle switch
  • Tx (comb meter)
  • Unified meter & a/c amplifier (behind center console)
  • Unified meter control unit
  • W/ intelligent key
  • W/o intelligent key
  • Withdrawn

Tire Pressure Monitoring Wiring Diagram for Infiniti FX45 2004

Tire Pressure Monitoring Wiring Diagram for Infiniti FX45 2004 https://portal-diagnostov.com/license.html
https://portal-diagnostov.com/license.html Automotive Electricians Portal FZCO Automotive Electricians Portal FZCO
Hanki pääsy kaikkiin auton kytkentäkaavioihinDownload PDF file

List of elements for Tire Pressure Monitoring Wiring Diagram for Infiniti FX45 2004:

  • (behind instrument cluster) m45
  • 12a
  • 15a
  • 5a m1
  • Acc
  • Ant input
  • Antenna
  • Bat (f/l)
  • Bat (fuse)
  • Batt
  • Body control module (bcm) (behind left kick panel)
  • Can-h
  • Can-l
  • Combination meter
  • Computer data lines system
  • Data link connector (lower left side of dash)
  • Diag-id input
  • Display control unit (right side of dash)
  • Exterior lights system
  • Flsher output (left)
  • Flsher output (right)
  • Fuse & fusible link block (right rear of engine compartment)
  • Fuse 10a
  • Fuse 15a
  • Fuse block (j/b) (behind left kick panel)
  • Fusible link m 50a
  • Gnd
  • Gnd (power)
  • Gnd (signal)
  • Hazard
  • Hazard sw
  • Hot at all times
  • Hot in acc or on
  • Hot in on or start
  • Ign
  • Ign sw
  • Low tire pressure warning control unit (right side of dash)
  • M20
  • M45 (behind instrument cluster)
  • M55
  • M56
  • M74
  • M85 (right end of dash)
  • Nca
  • R102
  • Red
  • Rx (comb meter)
  • Tire pressure ind
  • Tire pressure sensor
  • Tire pressure warning check switch
  • Tx (comb meter)
  • Unified meter & a/c amplifier (behind center console)
  • Unified meter control unit