POWER DOOR LOCKS – Chevrolet Beretta 1995 – SYSTEM WIRING DIAGRAMS

POWER DOOR LOCKS

Power Door Lock Wiring Diagram for Chevrolet Beretta 1995

List of elements for Power Door Lock Wiring Diagram for Chevrolet Beretta 1995:

• (behind left lower kick panel)
• (left rear of engine, on transaxle stud)
• (notused)
• (vin 4)
• (vin 4) (vin m)
• (vin m)
• 1995 vftc c
• Auto door unlock module (rifght side of i/p, near derm module)
• Bat
• C2 c2
• Circuit breaker 15 30a
• Door lock
• Engine control module (right upper i/p attached to bracket)
• Engine control module (right upper i/p, attached to bracket)
• Engine controls system
• Fuse 10a
• Fuse 20a
• Fuse block
• G104 (left rear of engine compartment, on transaxle stud)
• G114
• G117 (right rear of engine on transaxle stud)
• G300 (below driver's seat)
• Gnd
• Hot at all times
• Hot in run, bulb test or start
• Ign
• In-line fuse a 20a
• Left door lock switch
• Left front door lock motor
• Left rear door lock motor (4-door only)
• Lock
• Lock relay
• Multi- function alarm module (in convenience center)
• Park/ neutral input
• Park/ neutral position switch (top right side of transaxle)
• Pnk
• Relay assembly
• Relay control
• Right front door lock motor
• Right rear door lock motor (4-door only)
• Right door lock switch
• Solid state
• Tan
• Unlock
• Unlock control
• Unlock relay
• Vehicle speed input
• Viin 4 with a/t
• Vin 4 w/ m/t
• Vin m