CRUISE CONTROL – Toyota Sienna CE 2001 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Toyota Sienna CE 2001

List of elements for Cruise Control Wiring Diagram for Toyota Sienna CE 2001:

• (w/ vsc)
• (w/o vsc)
• A13
• Abs & traction ecu (translate ecu) (behind upper left end of dash)
• B10
• B14
• B18
• C10
• C22
• Cancel
• Ccs
• Cig fuse 15a
• Combination meter
• Combination switch
• Cruise
• Cruise control actuator (on left side of engine compartment)
• Cruise control ecu (behind upper left center of dash)
• Cruise control indicator
• Cruise control switch
• D position switch (park/neutral position switch) (on transaxle)
• D13
• Data link connector 1 (on right rear of engine compt)
• Data link connector 3 (below dash, right of steering column)
• Diode (park/neutral position switch) (behind upper left center of dash)
• Driver side j/b 1 (behind dash, left of steering column)
• E10
• Ect
• Ecu-ig fuse 15a
• Electronically controlled transmission solenoid (on left side of transaxle)
• Engine control module (behind right side of dash)
• G202 (left side of dash)
• G206 (right instrument panel brace)
• Gauge fuse 10a
• Gnd
• Hot at all times
• Hot in acc or on
• Hot in on or start
• I2 (dash harn, behind left side of dash)
• Idl
• Idlo
• J/b 3 (behind instrument cluster)
• J/c 13 (behind lower right side of dash)
• J/c 17 (behind upper right side of dash)
• J/c 18 (on underside of steering column)
• Od1
• Pnk
• Resume/ accel
• Set/ coast
• Spd
• Stop fuse 15a
• Stoplight switch (on bracket, above brake pedal)
• Stp