SHIFT INTERLOCK – Chevrolet Impala LS 2008 – SYSTEM WIRING DIAGRAMS

SHIFT INTERLOCK

Ignition Lock Solenoid Wiring Diagram for Chevrolet Impala LS 2008

List of elements for Ignition Lock Solenoid Wiring Diagram for Chevrolet Impala LS 2008:

• (closed in park)
• (front of dash, above g202) g201
• A/t shift lock control solenoid (w/ floor shifter: under center console) (w/o floor shifter: attached to right side of steering column)
• Ground distribution system
• Hot w/ rap relay energized
• I/p fuse block (in right front kick panel)
• Ignition lock cylinder control actuator (right side of steering column)
• Ignition lock cylinder control switch
• Power distribution system
• Rap fuse 10a

Shift Interlock Wiring Diagram for Chevrolet Impala LS 2008

List of elements for Shift Interlock Wiring Diagram for Chevrolet Impala LS 2008:

• (except 5.3l: on transmission to engine bolt, above starter) (5.3l: on transmission to engine bolt, below starter) g111
• (front of dash, above g202)
• (left of steering column)
• (right side of brake pedal bracket) brake pedal position sensor
• 5 volt ref
• 5.3l except 5.3l
• A/t shift lock control solenoid (attached to right side of steering column)
• A/t shift lock control solenoid (under center console)
• Automatic transaxle
• Battery positive voltage
• Body control module (bcm)
• Computer data
• Computer data lines system
• Engine control module (ecm) (inside air cleaner assembly)
• G201
• G302 (below passenger front door opening,
• Gmlan serial data bus (+)
• Gmlan serial data bus (-)
• Hot at all times
• J101
• J375
• Lines system
• Low ref
• Park/neutral sig x3
• Rear of right "a" pillar)
• Rvc sen fuse 10a
• Stop lamp sw sig
• Tan
• Transmission internal mode switch (ims)
• Underhood fuse block (mounted to right strut tower)
• W/ floor shifter
• W/o floor shifter