CRUISE CONTROL
Cruise Control Wiring Diagram for Mitsubishi Outlander LS 2005
List of elements for Cruise Control Wiring Diagram for Mitsubishi Outlander LS 2005:
- (on engine compartment relay box) mfi relay
- Acc
- Accelerator pedal position
- Accelerator pedal position sensor (at right rear of engine compt)
- Air conditioning system
- Auto-cruise control switch
- C04
- C05
- C103
- C109
- C110
- C111
- C112
- C202
- C205
- C308
- C309
- Can
- Clock spring (under steering wheel)
- Combination meter
- Compartment relay box (on left side of engine compt)
- Computer data lines system
- Cruise ind
- Engine
- Engine controls system
- Exterior lights system
- Fuse 15a
- Fuse 20a
- Fuse 7.5a
- G4 (behind right side of dash)
- G5 (behind lower right side of dash)
- Hot at all times
- Hot in on or start
- Ignition switch
- Joint connector 1 (behind right side of dash, taped to harness)
- Joint connector 2 (behind right side of dash, taped to harness)
- Junction block (behind left end of dash)
- Lock
- Main
- Off
- On off
- Output shaft speed sensor (on top right of transaxle)
- Powertrain control module (behind glove box)
- Red
- Res
- Set
- Start
- Starting/ charging system
- Stoplight switch (above brake pedal, on bracket)
- Switch
- Throttle actuator control motor
- Throttle actuator control motor relay (on engine compt relay box)
- Throttle position sensor (on throttle body)
- Transmission range switch (at left front of engine compt)