CRUISE CONTROL – Nissan Quest S 2007 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Quest S 2007

List of elements for Cruise Control Wiring Diagram for Nissan Quest S 2007:

• (right side of engine compt) e24
• 1q e30
• Accelerator pedal position sensor (behind left side of dash)
• Aps1
• Aps2
• Ascd brake switch (behind left side of dash)
• Ascd steering switch
• Ascd sw
• Avcc
• Avcc2
• Bnc sw
• Brake
• Can-h
• Can-l
• Cancel switch
• Close
• Combination meter
• Computer data lines system
• Cruise ind
• E16
• E24 (right side of engine compt)
• Ecm (right rear of engine compt)
• Electric throttle control actuator (left rear of engine compt)
• F54
• Fuse 10a
• Fuse 15a
• Fuse block (j/b) (behind left side of dash)
• Gnd
• Gnd-a
• Gnd-a2
• Hot at all times
• Hot in on or start
• M102
• M30
• M79 (behind right end of dash)
• Main switch
• Motor 1
• Motor 2
• Nca
• Open
• Pnk
• Red
• Resume/accel switch
• Sensor 1
• Sensor 2
• Set ind
• Set/coast switch
• Spiral cable (combination switch) (behind left side of dash)
• Stop lamp switch (behind left side of dash)
• Tps1
• Tps2
• Unified meter control unit