CRUISE CONTROL – Nissan Versa S 2010 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Versa S 2010

List of elements for Cruise Control Wiring Diagram for Nissan Versa S 2010:

• (behind left end of dash) transmission control module (tcm)
• (right side of transaxle) (cvt) secondary speed sensor
• Accel/res switch
• Accelerator pedal position sensor (behind left side of dash)
• Aps1
• Aps2
• Ascd brake switch (1.8l) (on brake pedal bracket)
• Ascd clutch switch (1.8l) (on clutch pedal bracket)
• Ascd steering switch (1.8l)
• Ascdsw
• Avcc-aps1
• Avcc-tps
• Avcc2-aps2
• Bnc sw
• Brake sw
• Can-h
• Can-l
• Cancel switch
• Close
• Coast/ set switch
• Combination meter
• Computer data lines system
• Cruise ind (w/ascd)
• E16
• E32
• E43
• Ecm (engine control module) (left side of engine compt)
• Electric throttle control actuator (on throttle body)
• Except m/t
• F10
• F11
• Fuse 13 10a
• Fuse 2 10a
• Fuse 3 10a
• Fuse 49 10a
• Fuse 7 10a
• Fuse block (j/b) (under left end of dash)
• Gnd
• Gnd-aps1
• Gnd-aps2
• Gnd-ascdsw
• Gnd-tps
• Hot at all all times
• Hot in on or start
• Ipdm e/r (intelligent power distribution module engine room) (left side of engine compt)
• M/t
• M30
• M31
• M61 (behind right side of dash)
• Motor 1
• Motor 2
• On/off (main) switch
• Open
• Pnk
• Pri spd sens
• Primary speed sensor
• Red
• Sec spd sens
• Sens gnd
• Sensor 1
• Sensor 2
• Set ind (w/ascd)
• Spd sens
• Spd sens (gnd)
• Spiral cable (combination switch) (in steering column)
• Stop lamp switch (on brake pedal bracket)
• Tps1
• Tps2
• Unified meter control unit
• Vehicle speed sensor (w/o abs or cvt) (on top right side of transmission)