FUSES & CIRCUIT BREAKERS Fuses & Circuit Breakers - 1992-95 Jeep Wrangler

Jeep Wrangler Sahara 1993 - IDENTIFICATION ELECTRICAL FAILURE

If an electrical device stops working with ignition and control switches in the ON positions, check for blown fuse in the appropriate circuit.

Jeep Wrangler Sahara 1993 - FUSE PANEL IDENTIFICATION (1992-95)

NOTE:

For fuse panel identification, refer to FUSES & CIRCUIT BREAKERS .

Jeep Wrangler Sahara 1993 - FUSE & CIRCUIT BREAKER IDENTIFICATION

NOTE:

For fuse and circuit breaker identification, refer to FUSES & CIRCUIT BREAKERS .

Jeep Wrangler Sahara 1993 - POWER DISTRIBUTION CENTER IDENTIFICATION (1992-95)

WARNING:

Always disconnect battery ground cable before servicing "high-current fuses. It is recommended that "high-current" fuses be replaced by a qualified technician.

NOTE:

For power distribution center identification, refer to FUSES & CIRCUIT BREAKERS .

Jeep Wrangler Sahara 1993 - RELAY IDENTIFICATION

• A - Not Used
• B - Fuel Pump Relay
• C - Air Conditioning Relay
• D - Auto Shutdown Relay
• E - Starter Relay
• F - Fog Lamp Relay
• G - Not Used

Jeep Wrangler Sahara 1993 - CAUTIONS & WARNINGS BATTERY

WARNING:

When battery is disconnected, vehicles equipped with computers may lose memory data. When battery power is restored, driveability problems may exist on some vehicles. These vehicles may require a relearn procedure. See the COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION section.

Jeep Wrangler Sahara 1993 - SUPPLEMENTAL RESTRAINT (AIR BAG SYSTEM) (IF EQUIPPED)

WARNING:

The Diagnostic Energy Reserve Module (DERM) can maintain enough voltage to cause a deployment of the Inflator Module for up to 10 minutes after the Ignition Switch is turned off and the battery is disconnected. Many of the service procedures require disconnection of the Inflator Module to avoid an accidental deployment.