GROUND DISTRIBUTION – Chevrolet Metro LSi 1999 – SYSTEM WIRING DIAGRAMS

GROUND DISTRIBUTION

Ground Distribution Wiring Diagram (1 of 3) for Chevrolet Metro LSi 1999

List of elements for Ground Distribution Wiring Diagram (1 of 3) for Chevrolet Metro LSi 1999:

• c1
• (main harness, approx 8cm from bulkhead grommet, near master cylinder)
• (with abs) lamp driver relay
• A/c 2 relay (condenser
• A/c compressor control module
• Battery
• Braid
• Brake fluid level switch
• Camshaft position sensor
• Crankshaft position sensor shield
• D c2
• Daytime running lamps control module
• Distributor shield
• Electronic brake control module
• Engine cooling fan motor
• Fan)
• Front washer pump
• G100 (lh front engine compartment, on lh front inner fender near battery)
• G108 (lh front engine compartment, front of battery)
• G130 (mounted on top lh side of transaxle)
• G131 (center rear of engine, on intake manifold)
• G200 (behind left kick panel)
• Heated oxygen sensor 1 shield
• Heated oxygen sensor 2 shield
• Horn
• Idle air control valve (vin 9)
• Idle speed control motor
• Ignition coil no 1 (vin 9)
• Ignition coil no 2 (vin 9)
• Left front park/turn lamp
• Left parking lamp
• Light 2 relay
• Powertrain control module
• Rear washer pump
• Relay box
• S113 (main harness, approx 6cm from left front turn lamp connector breakout)
• S115 (main harness, near rear washer pump)
• S130 (engine harness, near generator connector breakout)
• S165 (engine harn, near starter breakout)
• S207 (main harness, approx 15cm from g200)
• S208 (main harness, 2cm from junction block connector c8 breakout)
• S209
• S210 (main harness, left side of dash)
• S213 (main harn, near master cylinder)
• S247 (main harness, left rear of engine compt)
• S248 (engine harn, at pcm branch breakout)
• S263 (engine harn, at pcm branch breakout)
• To j/b (diagram 2 of 3)
• To s111 (diagram 2 of 3)
• Vin 9
• W/ abs

Ground Distribution Wiring Diagram (2 of 3) for Chevrolet Metro LSi 1999

List of elements for Ground Distribution Wiring Diagram (2 of 3) for Chevrolet Metro LSi 1999:

• (4-door)
• (i/p harness, approx 5cm from cigar lighter connector breakout) s243
• (not used)
• (with a/c) a/c switch
• A/c condenser fan
• Audio alarm module
• Blower motor
• C210
• Center high mounted stop lamp
• Cigar lighter
• Combination switch
• Data link connector on-board diagnostic ii
• Data link connector- on-board diagnostic ii
• Dimmer switch
• Dome lamp
• Dual pressure switch
• Early fuel evaporation heater
• From g131 (diagram 1 of 3)
• From s209 (diagram 1 of 3)
• Front wiper/ washer switch
• G101 (rh front engine compartment, on right front inner fender)
• G131 (center rear of engine)
• G202 (left side of dash)
• G206 (right center of dash, behind radio)
• G410 (2-door) (center of hatchback door, near rear wiper motor)
• Ignition control module
• Ignition switch
• Illumination controller
• Instrument panel cluster assembly
• Junction block
• Left power door lock switch
• Light switch
• Noise suppressor filter
• Power door lock control module
• Radio
• Rear defogger switch
• Rear wiper motor
• Red
• Right front park/turn lamp
• Right parking lamp
• Right power door lock switch
• S111 (main harness, near ignition coil connector breakout)
• S117 (main harn, near g101 breakout)
• S134 (engine harn, 22cm from bulkhead grommet, center of firewall)
• S235 (i/p harness, left side of dash)
• S236 (i/p harness, 8cm from i/p cluster c3 breakout)
• S237 (i/p harness, 10cm from radio conn breakout)
• S238 (i/p harn, near blower motor breakout)
• S239 (i/p harness, approx 11cm from i/p cluster c3 breakout)
• S240 (i/p harness, approx 6cm from dlc-obd ii breakout)
• S245 (i/p harn, 12cm from dash cluster breakout)
• S254 (i/p harness, center of dash)
• S314 (floor harn, left side of dash)
• Turn relay
• Vin

Ground Distribution Wiring Diagram (3 of 3) for Chevrolet Metro LSi 1999

List of elements for Ground Distribution Wiring Diagram (3 of 3) for Chevrolet Metro LSi 1999:

• (floor harness, approx 20cm from center console branch breakout) s301
• (floor harness, approx 20cm from left rear combination lamp conn breakout) s407
• (floor harness, approx 5cm from left rear combination lamp connector breakout) s402
• 2 door
• 4 door
• Below right rear seat)
• Center high mounted stop lamp
• Fuel sender assembly
• G203 (behind right kick panel)
• G407 (rear center of lug- gage compartment, near deck lid striker)
• G411 (2-door) (left side of hatch- back door, behind trim panel)
• G413 (4-door) (behind right rear quarter trim panel)
• Inflatable restraint forward discriminating sensor
• Left rear combination lamp
• License plate lamp
• Rear defogger
• Red
• Right rear combination lamp
• S311 (floor harness, approx 10cm from breakout to luggage compartment harness)
• S315 (fuel tank jumper harness,
• S403 (floor harness, approx 5cm from g407 breakout)
• S406 (floor harness, approx 10cm from left rear combination lamp connector breakout)
• S408 (floor harness)
• S411 (right rear combination lamp pigtail, approx 6cm from grommet at right rear of trunk)
• S413 (left rear combination lamp pigtail, approx 6cm from grommet at left rear of trunk)
• Seat belt switch
• Sensing and diagnostic module
• Shift lock solenoid
• Under right rear seat)