SUPPLEMENTAL RESTRAINTS – Chevrolet Chevy Express G2500 2001 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Chevrolet Chevy Express G2500 2001

List of elements for Supplemental Restraint Wiring Diagram for Chevrolet Chevy Express G2500 2001:

• (behind left kick panel, near i/p fuse block) g200
• (behind left kick panel, near power door lock control module) g200
• (in i/p harness, approximately 4 cm (2 in) from 48 cavity connector at base of steering column, pnk
• 2 ohms
• 4 cm (2 in) from park brake warning switch breakout) s201
• A10
• A11
• A12
• A13
• A14
• A15
• A16
• A17
• A18
• Air bag indicator
• Air bags fuse 10 10a
• B17
• Base
• Class 2 serial data
• Data link connector (dlc) (partial) (under left side of dash)
• Gauges fuse 4 10a
• Ground
• High control
• Hot in run & start
• I/p fuse block (on left lower kick panel)
• Ignition
• Indicator control
• Inflatable restraint diagnostic resistor
• Inflatable restraint front end discriminating sensor (on lower center of radiator support)
• Inflatable restraint ip module
• Inflatable restraint sensing & diagnostic module (under left front seat)
• Inflatable restraint steering wheel module
• Inflatable restraint steering wheel module coil
• Instrument panel cluster (ipc)
• Low control
• Multi-function alarm module (under left side of dash)
• Nca
• Ohms
• Over gvw
• Pnk
• S207 (in i/p harness, approximately 6 cm (2 in) from park brake warning switch breakout, toward data link connector (dlc))
• S209 (in i/p harness, approximately 39 cm (16 in) from 36-way in-line connector, left rear of engine compartment at firewall, toward inflatable restraint sensing & diagnostic module)
• Seat belt switch
• Seat belt switch (open when buckled) (at driver's stationary belt connector)
• Sensor signal
• Shorting bar
• Toward instrument cluster breakout) s216