WARNING SYSTEMS – Chevrolet Corvette 2006 – SYSTEM WIRING DIAGRAMS

WARNING SYSTEMS

Warning Systems Wiring Diagram for Chevrolet Corvette 2006

List of elements for Warning Systems Wiring Diagram for Chevrolet Corvette 2006:

• Ajar
• Audible alarm
• Auto
• Bcm class 2 serial data
• Bcm high spd gmlan serial data bus +
• Bcm high spd gmlan serial data bus -
• Body control module (bcm) (mounted on toe board, in right footwell)
• C1 a5
• Class 2 (rcdlr)
• Class 2 (sdm)
• Closed
• Computer data lines system
• Driver door latch
• Driver seat belt switch (in driver's seat belt buckle assembly)
• Ecm high spd gmlan serial data bus +
• Ecm high spd gmlan serial data bus -
• Engine control module (ecm) (behind right front fender, between wheelhouse & dash panel)
• G201 (at base of left "a" pillar)
• G301 (at left "b" pillar, behind trim panel)
• Head
• Inflatable restraint sensing & diagnostic module (sdm) (below center of dash, under hvac control head)
• Instrument panel cluster (ipc)
• Internal antenna
• Ipc
• Ipc class 2 serial data
• Left front tire pressure monitor sensor
• Left rear tire pressure monitor sensor
• Left seat belt sw
• Lf dr open sw sig
• Lf turn sig sw
• Logic
• Low ref
• Low tire pressure ind
• Message center
• Message request
• Nca
• Off
• Open
• Park
• Pk lmp sw on sig
• Pnk
• Remote control door lock receiver (rcdlr) (right side of dash)
• Rf turn sig sw
• Rfa class 2 serial data
• Right front tire pressure monitor sensor
• Right rear tire pressure monitor sensor
• S221
• S275
• S301
• S391 (front body harness, 15 cm from passenger rear speaker breakout)
• Sdm class 2 serial data
• Seat belt ind
• Solid state
• Tan
• Turn signal/ multifunction switch