Dodge Colt Vista 1990 - FUSES & CIRCUIT BREAKERS Fuses & Circuit Breakers 1984-91 Chrysler Motors

Dodge Colt Vista 1990 - IDENTIFICATION FUSE PANEL IDENTIFICATION (1984-91 MODELS)

Fuse panel is located under instrument panel on driver's side of vehicle. Fusible link wires are used to protect a number of circuits. These links will melt in the event of excessive current flow. Replace after determining cause.

Fig. 1: Dodge Colt Vista 1990 - Component Locations - Fuse Panel Identification (1984-91)

Dodge Colt Vista 1990 - FUSE & CIRCUIT BREAKER IDENTIFICATION 1 - 10 Amp

Dome Light.

Dodge Colt Vista 1990 - 2 - 10 Amp

Stoplights.

Dodge Colt Vista 1990 - 3 - 10 Amp

Hazard.

Dodge Colt Vista 1990 - 4 - 20 Amp (1984-89); Blank (1990-91)

Defogger (1984-89); Not Used (1990-91).

Dodge Colt Vista 1990 - 5 - 20 Amp

Heater.

Dodge Colt Vista 1990 - 6 - 10 Amp

Horn.

Dodge Colt Vista 1990 - 7 - 15 Amp

Wiper.

Dodge Colt Vista 1990 - 8 - 15 Amp

Radio.

Dodge Colt Vista 1990 - 9 - 10 Amp

Turn Signals.

Dodge Colt Vista 1990 - 10 - 10 Amp

Back-Up Lights.

Dodge Colt Vista 1990 - 11 - 10 Amp

Liftgate (1984); Taillights (1985-91).

Dodge Colt Vista 1990 - 12 - Blank

Not Used.

Dodge Colt Vista 1990 - CAUTIONS & WARNINGS BATTERY

WARNING:

When battery is disconnected, vehicles equipped with computers may lose memory data. When battery power is restored, driveability problems may exist on some vehicles. These vehicles may require a relearn procedure. See the COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION section.

Dodge Colt Vista 1990 - SUPPLEMENTAL RESTRAINT (AIR BAG SYSTEM) (IF EQUIPPED)

WARNING:

The Diagnostic Energy Reserve Module (DERM) can maintain enough voltage to cause a deployment of the Inflator Module for up to 10 minutes after the Ignition Switch is turned off and the battery is disconnected. Many of the service procedures require disconnection of the Inflator Module to avoid an accidental deployment.