ANTI-LOCK BRAKES – Ford Econoline E250 2000 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brakes Wiring Diagram for Ford Econoline E250 2000

List of elements for Anti-lock Brakes Wiring Diagram for Ford Econoline E250 2000:

• (below left side of dash)
• (left front of engine compartment) low vacuum warning switch
• (not used)
• 4 wheel anti-lock brake system (4wabs) module (on left front frame rail)
• 4-wheel anti- lock brakes (4wabs) relay (behind center of dash)
• 87a
• Abs warning lamp output
• Accy
• Anti-lock brake indicator
• Battery junction box (in left front of engine compartment)
• Bpp switch input
• Brake pedal position (bpp) switch (on bracket, above brake pedal)
• Brake warn lamp high
• Brake warning indicator
• Brake warning lamp low
• C144
• C145
• C225
• C226
• Central junction box (left side of dash, near kick panel)
• Data link conn
• Data link connector (below left side of dash)
• Diesel
• Dual brake warning switch (left side of engine compt, bottom of brake master cylinder)
• Electronic crash sensor (ecs) module (behind right side of dash)
• Fuse 1 20a
• Fuse 11 15a
• Fuse 19 60a
• Fuse 2 15a
• G101 (front of right front fender)
• G108 (left upper radiator support)
• G202 (behind upper left side of dash)
• Ground
• Hot at all times
• Hot in run or start
• Ignition switch
• Instrument cluster
• Instrument cluster system
• Left front sensor high
• Left front sensor low
• Left front wheel speed sensor
• Lock
• Nca
• Off
• Ohm
• Power
• Rear axle speed sensor
• Rear sensor high
• Rear sensor low
• Red/pnk
• Relay ctrl output
• Right front sensor high
• Right front sensor low
• Right front wheel speed sensor
• Run
• S119 (left rear of engine compt)
• S122
• S125 (left side of engine compt)
• S132 (right rear of engine compt)
• S134 (engine control harness, near breakout for a/c pressure cutout switch)
• S143
• S207
• S213
• S220 (top of steering column)
• S228
• Start