INSTRUMENT CLUSTER
Instrument Cluster Wiring Diagram for Mazda Protege ES 1998
List of elements for Instrument Cluster Wiring Diagram for Mazda Protege ES 1998:
- Abs ind
- Air bag ind
- Anti-lock brakes
- Beam ind
- Brake fluid level sensor (in bottom of brake fluid reservoir)
- Brake ind
- Buckle switch (on driver's side seat belt buckle)
- Buzzer
- Canada only
- Charge ind
- Check eng ind
- Cigar, radio fuse 15a
- Conn 1
- Conn 2
- Conn 3
- Cruise control
- Cruise ind
- Defogger
- Door ind
- Engine controls
- Engine controls, cruise control
- Exterior lights
- Fuel gauge
- Fuel gauge sender unit (in fuel tank)
- G107
- G200
- G300
- Hazard ind
- Headlights
- Hot at all times
- Hot in run or acc
- Hot in run or start
- Illumination lamps
- Instrument cluster
- Interior lights
- Jc-01 (left kick panel)
- Jc-02 (below left front seat)
- Jc-04 (behind right headlight)
- Joint box (behind left side of dash)
- Key reminder switch (at ignition switch)
- Left turn ind
- Low fuel ind
- Meter fuse 15a
- Micro computer
- O/d off ind
- Odometer/ tripmeter switch
- Oil ind
- Oil pressure switch (on right side of eng block, near oil filter)
- Parking brake switch (at base of parking brake lever)
- Rear def ind
- Red
- Right turn ind
- Room fuse 10a
- Seat belt ind
- Speedo- meter
- Starting/ charging
- Starting/charging
- Tacho- meter
- Temp gauge
- Vehicle speedometer sensor (on left side of engine compt, in transaxle)
- Washer fluid level sensor (on washer fluid reservoir, in right front of engine compt) (canada)
- Washer ind (canada)
- Water temperature sender unit (on upper rear of engine)
- X27 (left kick panel)