INTERIOR LIGHTS – Chevrolet Metro 1998 – SYSTEM WIRING DIAGRAMS

INTERIOR LIGHTS

Interior Light Wiring Diagram for Chevrolet Metro 1998

List of elements for Interior Light Wiring Diagram for Chevrolet Metro 1998:

• (4-door)
• (i/p harn, behind left side of dash) s217
• (i/p harness, approx 4 cm from data link connector- on board diagnostics ii breakout) s252
• (i/p harness, approx 6 cm from diode module connector breakout)
• (left side of dash) junction block
• (main harness, approx 2 cm from bulkhead grommet near master cylinder) s204
• (not used)
• (not used)
• (right side of dash, behind radio)
• 2-door
• Audio alarm module (behind dash, left of steering column)
• Bulbs
• C10
• Combination switch
• Diode no 1 (near audio alarm module)
• Dome fuse 15a
• Dome lamp
• Door
• Engine controls system
• Exterior lights system
• G202
• G206
• Ground
• Head
• Heater control unit illumination lamp
• Hot at all times
• Illumination controller
• Instrument panel cluster assembly
• Junction block (behind left side of dash)
• Junction block (on left side of dash)
• Left front door jamb switch
• Light 1 relay (on relay box)
• Light switch
• Luggage compartment lamp
• Luggage compartment lamp switch
• Manual selector lever illumination lamp (a/t)
• Off
• Park
• Power
• Radio
• Rear defogger switch
• Rear wiper/washer switch
• S218 (i/p harness, approx 3 cm from i/p cluster c3 breakout)
• S219 (i/p harn, behind left side of dash)
• S221 (i/p harness, approx 7 cm from i/p cluster c2 breakout)
• S222
• S228 (i/p harness, behind left side of dash)
• S229 (i/p harness, approx 4 cm from i/p cluster c1 breakout)
• S230 (i/p harness, 13 cm from i/p cluster c3 breakout)
• S239
• S254
• S302 (floor harn, behind left side of dash)
• S310 (floor harness, approx 6 cm from junction block conn breakout)
• S419 (floor harness, approx 21 cm from right rear door jamb sw conn breakout)
• Tail fuse 15a
• Warning system