STARTING/CHARGING – Jeep Wrangler Rubicon 2004 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Jeep Wrangler Rubicon 2004

List of elements for Charging Wiring Diagram for Jeep Wrangler Rubicon 2004:

• (behind left side of dash, near breakout to c202,c203 & c204) s209
• (near breakout for ignition coil pack)
• (near breakout to g100, on left center of firewall) s113
• (near rear of generator) g104
• (on center of firewall, near breakout to underhood lamp)
• (run- start)
• A/t
• A11
• A13
• A14
• A15
• Asd rly ctrl
• Asd rly out
• Automatic shut down relay (in power distribution center)
• B(+)
• Battery
• Battery temper- ature sensor (on bottom of battery tray)
• Check gauges
• Check gauges indicator
• Dk k20
• Engine controls system
• Engine starter motor
• F15
• Fuel pump relay
• Fuse 10a
• Fuse 30a
• Fuse block (under right center of dash)
• Fused b(+)
• Fused ignition switch output
• G106 (on right rear of engine block)
• G107 (on right rear of engine block)
• Gen fld dvr
• Gen fld sre
• Generator
• Hot in run or start
• Ign
• Instrument cluster
• K118
• K51
• M/t
• Nca
• Pci bus
• Pnk
• Power distribution center (on right side of engine compt)
• Powertrain control module (in right rear of engine compartment, on firewall)
• Red
• S101 (near breakout to pdc)
• S136 (in battery harness, near pdc)
• S147
• S161
• S215
• Sensor ground
• Sensor signal
• Voltmeter

Starting Wiring Diagram for Jeep Wrangler Rubicon 2004

List of elements for Starting Wiring Diagram for Jeep Wrangler Rubicon 2004:

• (2.4l: between engine starter solenoid & c182) (4.0l: near breakout for c154)
• (a/t)
• (m/t)
• A/t
• Acc
• Battery
• Clutch pedal position switch (top of clutch pedal bracket)
• Engine starter motor
• Engine starter motor relay (in pdc)
• Fuse 20a
• Fuse 30a
• Fuse block (under right center of dash)
• G105 (2.4l: near left engine mount) (4.0l: right rear of engine block)
• G106 (on right rear of engine block)
• G107 (on right rear of engine block)
• Hold- in
• Ignition switch
• Lock
• M/t
• Near 100-way connector)
• Off
• P/n
• Power distribution center (on right side of engine compt)
• Powertrain control module (in right rear of engine compt, on firewall)
• Pull- in
• Red
• Run
• S111
• S132
• S134
• S172 (in harness, between g100 & c103)
• Start
• Transmission range sensor (at left center of transmission)